[PATCH v3 0/3] ARM/dts: omap3: Add DT support for IGEP devices

[Benoit Cousson]

Hi Javier,

On 12/12/2012 09:25 AM, Javier Martinez Canillas wrote:
> On Mon, Dec 3, 2012 at 1:41 PM, Javier Martinez Canillas
> <javier.martinez at collabora.co.uk> wrote:
>> IGEP technology devices are TI OMAP3 SoC based industrial embedded
>> and computer-on-module boards. This patch-set adds initial device
>> tree support for these devices.
>>
>> The device trees allows to boot from an MMC and are working all the
>> components that already have device tree support on OMAP3 SoCs:
>>
>> - MMC/SD
>> - UARTs
>> - GPIO LEDs
>> - TWL4030 codec audio
>> - pinmux/pinconf pinctrl
>>
>> Some peripheral are still not working such as Flash storage and
>> Ethernet but support for these will also be included once the
>> OMAP GPMC device tree binding patches land on mainline.
>>
>> This is a v3 of the patch-set that solves issues pointed out by
>> Enric Balletbo and Benoit Cousson.
>>
>> The patch-set is composed of the following patches:
>>
>> [PATCH v3 1/3] ARM/dts: omap3: Add generic DT support for IGEP devices
>> [PATCH v3 2/3] ARM/dts: omap3: Add support for IGEPv2 board
>> [PATCH v3 3/3] ARM/dts: omap3: Add support for IGEP COM Module
>>
>> Best regards,
>> Javier
>> --
> 
> Hi Benoit and Tony,
> 
> Any comments on these?

Nope, that's fine. I'll applied the series for 3.9.

Thanks,
Benoit