[PATCH 1/1] ARM: ux500: Change IRQ from low-to-high edge triggered to high-to-low

[Lee Jones]

On Sat, 01 Dec 2012, Linus Walleij wrote:

> On Fri, Nov 30, 2012 at 4:24 PM, Lee Jones <lee.jones at linaro.org> wrote:
> 
> > When the STMPE IRQ is triggered to be active high level-sensitive, the
> > Nomadik GPIO controller it uses complains, although it still works.
> > Recently we attempted to move triggering to low-to-high in an attempt
> > to prevent the warning; however, this ensured that the IRQ was actually
> > missed completely. Now we have a solution which both works and keeps the
> > GPIO controller happy.
> >
> > Signed-off-by: Lee Jones <lee.jones at linaro.org>
> 
> Acked-by: Linus Walleij <linus.walleij at linaro.org>
> 
> Is this something I should put into the ux500 tree or will you
> take care of this in a separate pull request?

Can you still get this into the RCs, as it's a bugfix?

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog