[PATCH 1/1] ARM: ux500: Change IRQ from low-to-high edge triggered to high-to-low

[Linus Walleij]

On Fri, Nov 30, 2012 at 4:24 PM, Lee Jones <lee.jones at linaro.org> wrote:

> When the STMPE IRQ is triggered to be active high level-sensitive, the
> Nomadik GPIO controller it uses complains, although it still works.
> Recently we attempted to move triggering to low-to-high in an attempt
> to prevent the warning; however, this ensured that the IRQ was actually
> missed completely. Now we have a solution which both works and keeps the
> GPIO controller happy.
>
> Signed-off-by: Lee Jones <lee.jones at linaro.org>

Acked-by: Linus Walleij <linus.walleij at linaro.org>

Is this something I should put into the ux500 tree or will you
take care of this in a separate pull request?

Yours,
Linus Walleij