[PATCH 04/22] ASoC: Ux500: Move MSP pinctrl setup into the MSP driver

[Lee Jones]

On Mon, Aug 27, 2012 at 04:09:46PM -0700, Linus Walleij wrote:
> On Mon, Aug 20, 2012 at 4:59 AM, Lee Jones <lee.jones at linaro.org> wrote:
> > On Tue, Aug 14, 2012 at 10:51:02AM +0200, Linus Walleij wrote:
> 
> >> But wait. These are just local statics. Surelty you can put these into
> >> struct ux500_msp instead? Here it looks like these will be used for
> >> all ports, so MSP2 will enable the pins requested by MSP1 etc
> >> completely broken. So put it into the struct ux500_msp state
> >> container from ux500_msp_i2s.h where it belongs.
> >>
> >> Refer to drivers/tty/serial/amba-pl011.c when in trouble. This
> >> one is a good pinctrl example.
> >
> > How do you see the MSP1 and MSP3 usage protection working if I hide it
> > all away in MSP specific structs?
> 
> Usage protection? Sorry not following. Please elaborate...

Don't worry about it, I think I sorted it.

Please see the lastest version of the patch (sent on 24th Aug).

-- 
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog