[PATCH 2/2] tty: serial: imx: don't reinit clock with enabled console

[Troy Kisky]

On 8/28/2012 11:27 AM, Troy Kisky wrote:
> On 8/28/2012 3:46 AM, Dirk Behme wrote:
>> On 27.08.2012 20:20, Troy Kisky wrote:
>>> On 8/27/2012 12:36 AM, Dirk Behme wrote:
>>>> From: Xinyu Chen <xinyu.chen at freescale.com>
>>>>
>>>> Remove the imx_setup_ufcr() call on startup when CONSOLE enabled,
>>>> as this will cause clock reinit, and output garbage.
>>>>
>>>> This patch is a port from Freescale's Android kernel.
>>>>
>>>> Signed-off-by: Xinyu Chen <xinyu.chen at freescale.com>
>>>> Tested-by: Dirk Behme <dirk.behme at de.bosch.com>
>>>> CC: Shawn Guo <shawn.guo at linaro.org>
>>>> CC: Sascha Hauer <s.hauer at pengutronix.de>
>>>> ---
>>>>   drivers/tty/serial/imx.c |    2 ++
>>>>   1 files changed, 2 insertions(+), 0 deletions(-)
>>>>
>>>> diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c
>>>> index 908178f..31ce414 100644
>>>> --- a/drivers/tty/serial/imx.c
>>>> +++ b/drivers/tty/serial/imx.c
>>>> @@ -695,7 +695,9 @@ static int imx_startup(struct uart_port *port)
>>>>       int retval;
>>>>       unsigned long flags, temp;
>>>>   +#ifndef CONFIG_SERIAL_CORE_CONSOLE
>>>>       imx_setup_ufcr(sport, 0);
>>>> +#endif
>>>>         /* disable the DREN bit (Data Ready interrupt enable) before
>>>>        * requesting IRQs
>>>
>>>
>>> I'd rather do something like this
>>>
>>> static int imx_setup_ufcr(struct imx_port *sport, unsigned int mode)
>>> {
>>>          unsigned int val;
>>>
>>>          /* set receiver / transmitter trigger level. */
>>>          val = readl(sport->port.membase + UFCR) & UFCR_RFDIV;
>>
>> Shouldn't it be
>>
>> ... & (UFCR_RFDIV | UFCR_DCEDTE);
>>
>> then? My i.MX6 manual has DCEDTE as bit 6, which we don't want to 
>> touch, too? We only want to touch TXTL and RXTL?
>>
>
> If you do that, you should also change imx_set_termios
> to possibly clear the bit
>
> new_ufcr = (old_ufcr & (~UFCR_RFDIV)) | UFCR_RFDIV_REG(div);
>
> to
>
> new_ufcr = (old_ufcr & (~(UFCR_RFDIV | UFCR_DCEDTE))) | 
> UFCR_RFDIV_REG(div);
>

Sorry, I was looking at the wrong tree. Mainline does not have

sport->use_dcedte. I'm fine either way.