[PATCH 5/6] ARM: dt: t30 cardhu: set pinmux and power for wlan
Wei Ni
wni at nvidia.com
Mon Aug 27 06:25:13 EDT 2012
Configure pinmux as required for WiFi.
Enable the SDHCI1 controller. This is connectted to the WiFi module.
For now, always enable the regulator that provides power to the Wifi module.
Signed-off-by: Wei Ni <wni at nvidia.com>
---
arch/arm/boot/dts/tegra30-cardhu.dtsi | 32 ++++++++++++++++++++++++++++++++
1 files changed, 32 insertions(+), 0 deletions(-)
diff --git a/arch/arm/boot/dts/tegra30-cardhu.dtsi b/arch/arm/boot/dts/tegra30-cardhu.dtsi
index 4794693..ed9b530 100644
--- a/arch/arm/boot/dts/tegra30-cardhu.dtsi
+++ b/arch/arm/boot/dts/tegra30-cardhu.dtsi
@@ -52,6 +52,22 @@
nvidia,pull = <2>;
nvidia,tristate = <0>;
};
+ sdmmc3_clk_pa6 {
+ nvidia,pins = "sdmmc3_clk_pa6";
+ nvidia,function = "sdmmc3";
+ nvidia,pull = <0>;
+ nvidia,tristate = <0>;
+ };
+ sdmmc3_cmd_pa7 {
+ nvidia,pins = "sdmmc3_cmd_pa7",
+ "sdmmc3_dat0_pb7",
+ "sdmmc3_dat1_pb6",
+ "sdmmc3_dat2_pb5",
+ "sdmmc3_dat3_pb4";
+ nvidia,function = "sdmmc3";
+ nvidia,pull = <2>;
+ nvidia,tristate = <0>;
+ };
sdmmc4_clk_pcc4 {
nvidia,pins = "sdmmc4_clk_pcc4",
"sdmmc4_rst_n_pcc3";
@@ -81,6 +97,15 @@
nvidia,pull = <0>;
nvidia,tristate = <0>;
};
+ sdio3 {
+ nvidia,pins = "drive_sdio3";
+ nvidia,high-speed-mode = <0>;
+ nvidia,schmitt = <0>;
+ nvidia,pull-down-strength = <46>;
+ nvidia,pull-up-strength = <42>;
+ nvidia,slew-rate-rising = <1>;
+ nvidia,slew-rate-falling = <1>;
+ };
};
};
@@ -292,6 +317,11 @@
bus-width = <4>;
};
+ sdhci at 78000400 {
+ status = "okay";
+ power-gpios = <&gpio 28 0>; /* gpio PD4 */
+ };
+
sdhci at 78000600 {
status = "okay";
bus-width = <8>;
@@ -407,6 +437,8 @@
regulator-name = "vdd_com";
regulator-min-microvolt = <3300000>;
regulator-max-microvolt = <3300000>;
+ regulator-always-on;
+ regulator-boot-on;
enable-active-high;
gpio = <&gpio 24 0>; /* gpio PD0 */
vin-supply = <&sys_3v3_reg>;
--
1.7.1
More information about the linux-arm-kernel
mailing list