[PATCH 2/4 V2] ARM: mx28: Add USB PHY overcurrent pinmux

[Shawn Guo]

On Sat, Aug 25, 2012 at 01:51:38AM +0200, Marek Vasut wrote:
> Add the pinmux settings for USB PHY overcurrent pins.
> 
> Signed-off-by: Marek Vasut <marex at denx.de>
> Cc: Chris Ball <cjb at laptop.org>
> Cc: Fabio Estevam <fabio.estevam at freescale.com>
> Cc: Mark Brown <broonie at opensource.wolfsonmicro.com>
> Cc: Shawn Guo <shawn.guo at linaro.org>
> ---
>  arch/arm/boot/dts/imx28.dtsi |   30 ++++++++++++++++++++++++++++++
>  1 file changed, 30 insertions(+)
> 
> V2: This is pulled from the M28EVK and SPS1 board files, put it into common
>     file.
> 
> diff --git a/arch/arm/boot/dts/imx28.dtsi b/arch/arm/boot/dts/imx28.dtsi
> index b996c2d..3cba62d 100644
> --- a/arch/arm/boot/dts/imx28.dtsi
> +++ b/arch/arm/boot/dts/imx28.dtsi
> @@ -520,6 +520,36 @@
>  					fsl,voltage = <1>;
>  					fsl,pull-up = <1>;
>  				};
> +
> +				usbphy0_pins_a: usbphy0 at 0 {
> +					reg = <0>;
> +					fsl,pinmux-ids = <
> +						0x2152 /* MX28_PAD_SSP2_SS2__USB0_OVERCURRENT */
> +					>;
> +					fsl,drive-strength = <2>;
> +					fsl,voltage = <1>;
> +					fsl,pull-up = <0>;
> +				};
> +
> +				usbphy0_pins_b: usbphy0 at 1 {
> +					reg = <0>;

This should be
					reg = <1>;

Fixed it up and applied the patch.

> +					fsl,pinmux-ids = <
> +						0x3061 /* MX28_PAD_AUART1_CTS__USB0_OVERCURRENT */
> +					>;
> +					fsl,drive-strength = <2>;
> +					fsl,voltage = <1>;
> +					fsl,pull-up = <0>;
> +				};
> +
> +				usbphy1_pins_a: usbphy1 at 0 {
> +					reg = <0>;
> +					fsl,pinmux-ids = <
> +						0x2142 /* MX28_PAD_SSP2_SS1__USB1_OVERCURRENT */
> +					>;
> +					fsl,drive-strength = <2>;
> +					fsl,voltage = <1>;
> +					fsl,pull-up = <0>;
> +				};
>  			};
>  
>  			digctl at 8001c000 {
> -- 
> 1.7.10.4
> 

-- 
Regards,
Shawn