[PATCH v3 19/23] serial: omap: make sure to put() on poll_get_char

[Felipe Balbi]

if we would reach serial_omap_get_char() while
Data Ready bit isn't set, we would return from
it without kicking our pm timer. This would mean
we would, eventually, have an unbalanced
pm_runtime_get on our device which would prevent
it from ever sleeping again.

Tested-by: Shubhrajyoti D <shubhrajyoti at ti.com>
Signed-off-by: Felipe Balbi <balbi at ti.com>
---
 drivers/tty/serial/omap-serial.c | 9 +++++++--
 1 file changed, 7 insertions(+), 2 deletions(-)

diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index d6f5eed..c3579c0 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -991,12 +991,17 @@ static int serial_omap_poll_get_char(struct uart_port *port)
 
 	pm_runtime_get_sync(up->dev);
 	status = serial_in(up, UART_LSR);
-	if (!(status & UART_LSR_DR))
-		return NO_POLL_CHAR;
+	if (!(status & UART_LSR_DR)) {
+		status = NO_POLL_CHAR;
+		goto out;
+	}
 
 	status = serial_in(up, UART_RX);
+
+out:
 	pm_runtime_mark_last_busy(up->dev);
 	pm_runtime_put_autosuspend(up->dev);
+
 	return status;
 }
 
-- 
1.7.12.rc3