[PATCH v2 2/4] pinctrl: add exynos4210 specific extensions for samsung pinctrl driver

[Linus Walleij]

On Wed, Aug 15, 2012 at 9:57 PM, Thomas Abraham
<thomas.abraham at linaro.org> wrote:

> Add information about the Exynos4210 pin banks and driver data which is
> used by the Samsung pinctrl driver. In addition to this, the support for
> external gpio and wakeup interrupt support is included and hooked up with
> the Samsung pinctrl driver.

OK...

> diff --git a/drivers/pinctrl/Kconfig b/drivers/pinctrl/Kconfig
> +config PINCTRL_EXYNOS4
> +       bool "Pinctrl driver data for Exynos4 SoC"
> +       depends on ARCH_EXYNOS4 && OF

Since you depend on PINCTRL_SAMSUNG which depends
on OF you don't need to depend on OF here.

> +       depends on PINCTRL_SAMSUNG
> +       select PINMUX
> +       select PINCONF

So as noted in the main driver, let PINCTRL_SAMSUNG
select PINMUX and PINCONF and you need only select
PINCTRL_SAMSUNG here.

> diff --git a/drivers/pinctrl/pinctrl-exynos.c b/drivers/pinctrl/pinctrl-exynos.c
(...)
> +#include <linux/interrupt.h>
> +#include <linux/irqdomain.h>
> +#include <linux/irq.h>
> +#include <linux/of_irq.h>

Do you need these includes? Didn't you put them
all in "pinctrl-samsung.h"?

Overall this looks good and straight-forward, but I cannot figure
out how the samsung_pinctrl_soc_data is passed to the main
driver, it seems to be through some DT node but I cannot figure
this out. Can you explain this?

Yours,
Linus Walleij