[PATCH v6 10/10] ARM: OMAP2+: tusb6010: generic timing calculation
Afzal Mohammed
afzal at ti.com
Tue Aug 21 06:46:07 EDT 2012
Generic gpmc timing calculation helper is available now, use
it instead of custom timing calculation.
Signed-off-by: Afzal Mohammed <afzal at ti.com>
---
arch/arm/mach-omap2/usb-tusb6010.c | 181 +++++++++---------------------------
1 files changed, 43 insertions(+), 138 deletions(-)
diff --git a/arch/arm/mach-omap2/usb-tusb6010.c b/arch/arm/mach-omap2/usb-tusb6010.c
index 7a85ebe..cce1f06 100644
--- a/arch/arm/mach-omap2/usb-tusb6010.c
+++ b/arch/arm/mach-omap2/usb-tusb6010.c
@@ -26,182 +26,87 @@ static u8 async_cs, sync_cs;
static unsigned refclk_psec;
-/* t2_ps, when quantized to fclk units, must happen no earlier than
- * the clock after after t1_NS.
- *
- * Return a possibly updated value of t2_ps, converted to nsec.
- */
-static unsigned
-next_clk(unsigned t1_NS, unsigned t2_ps, unsigned fclk_ps)
-{
- unsigned t1_ps = t1_NS * 1000;
- unsigned t1_f, t2_f;
-
- if ((t1_ps + fclk_ps) < t2_ps)
- return t2_ps / 1000;
-
- t1_f = (t1_ps + fclk_ps - 1) / fclk_ps;
- t2_f = (t2_ps + fclk_ps - 1) / fclk_ps;
-
- if (t1_f >= t2_f)
- t2_f = t1_f + 1;
-
- return (t2_f * fclk_ps) / 1000;
-}
-
/* NOTE: timings are from tusb 6010 datasheet Rev 1.8, 12-Sept 2006 */
-static int tusb_set_async_mode(unsigned sysclk_ps, unsigned fclk_ps)
+static int tusb_set_async_mode(unsigned sysclk_ps)
{
+ struct gpmc_device_timings dev_t;
struct gpmc_timings t;
unsigned t_acsnh_advnh = sysclk_ps + 3000;
- unsigned tmp;
-
- memset(&t, 0, sizeof(t));
-
- /* CS_ON = t_acsnh_acsnl */
- t.cs_on = 8;
- /* ADV_ON = t_acsnh_advnh - t_advn */
- t.adv_on = next_clk(t.cs_on, t_acsnh_advnh - 7000, fclk_ps);
-
- /*
- * READ ... from omap2420 TRM fig 12-13
- */
-
- /* ADV_RD_OFF = t_acsnh_advnh */
- t.adv_rd_off = next_clk(t.adv_on, t_acsnh_advnh, fclk_ps);
-
- /* OE_ON = t_acsnh_advnh + t_advn_oen (then wait for nRDY) */
- t.oe_on = next_clk(t.adv_on, t_acsnh_advnh + 1000, fclk_ps);
-
- /* ACCESS = counters continue only after nRDY */
- tmp = t.oe_on * 1000 + 300;
- t.access = next_clk(t.oe_on, tmp, fclk_ps);
-
- /* OE_OFF = after data gets sampled */
- tmp = t.access * 1000;
- t.oe_off = next_clk(t.access, tmp, fclk_ps);
-
- t.cs_rd_off = t.oe_off;
-
- tmp = t.cs_rd_off * 1000 + 7000 /* t_acsn_rdy_z */;
- t.rd_cycle = next_clk(t.cs_rd_off, tmp, fclk_ps);
-
- /*
- * WRITE ... from omap2420 TRM fig 12-15
- */
- /* ADV_WR_OFF = t_acsnh_advnh */
- t.adv_wr_off = t.adv_rd_off;
+ memset(&dev_t, 0, sizeof(dev_t));
- /* WE_ON = t_acsnh_advnh + t_advn_wen (then wait for nRDY) */
- t.we_on = next_clk(t.adv_wr_off, t_acsnh_advnh + 1000, fclk_ps);
+ dev_t.mux = true;
- /* WE_OFF = after data gets sampled */
- tmp = t.we_on * 1000 + 300;
- t.we_off = next_clk(t.we_on, tmp, fclk_ps);
+ dev_t.t_ceasu = 8 * 1000;
+ dev_t.t_avdasu = t_acsnh_advnh - 7000;
+ dev_t.t_ce_avd = 1000;
+ dev_t.t_avdp_r = t_acsnh_advnh;
+ dev_t.t_oeasu = t_acsnh_advnh + 1000;
+ dev_t.t_oe = 300;
+ dev_t.t_cez_r = dev_t.t_cez_w = 7000;
+ dev_t.t_avdp_w = t_acsnh_advnh;
+ dev_t.t_weasu = t_acsnh_advnh + 1000;
+ dev_t.t_wpl = 300;
+ dev_t.cyc_aavdh_we = 1;
- t.cs_wr_off = t.we_off;
-
- tmp = t.cs_wr_off * 1000 + 7000 /* t_acsn_rdy_z */;
- t.wr_cycle = next_clk(t.cs_wr_off, tmp, fclk_ps);
+ gpmc_calc_timings(&t, &dev_t);
return gpmc_cs_set_timings(async_cs, &t);
}
-static int tusb_set_sync_mode(unsigned sysclk_ps, unsigned fclk_ps)
+static int tusb_set_sync_mode(unsigned sysclk_ps)
{
+ struct gpmc_device_timings dev_t;
struct gpmc_timings t;
unsigned t_scsnh_advnh = sysclk_ps + 3000;
- unsigned tmp;
-
- memset(&t, 0, sizeof(t));
- t.cs_on = 8;
-
- /* ADV_ON = t_acsnh_advnh - t_advn */
- t.adv_on = next_clk(t.cs_on, t_scsnh_advnh - 7000, fclk_ps);
-
- /* GPMC_CLK rate = fclk rate / div */
- t.sync_clk = 11100 /* 11.1 nsec */;
- tmp = (t.sync_clk + fclk_ps - 1) / fclk_ps;
- if (tmp > 4)
- return -ERANGE;
- if (tmp == 0)
- tmp = 1;
- t.page_burst_access = (fclk_ps * tmp) / 1000;
-
- /*
- * READ ... based on omap2420 TRM fig 12-19, 12-20
- */
-
- /* ADV_RD_OFF = t_scsnh_advnh */
- t.adv_rd_off = next_clk(t.adv_on, t_scsnh_advnh, fclk_ps);
-
- /* OE_ON = t_scsnh_advnh + t_advn_oen * fclk_ps (then wait for nRDY) */
- tmp = (t.adv_rd_off * 1000) + (3 * fclk_ps);
- t.oe_on = next_clk(t.adv_on, tmp, fclk_ps);
-
- /* ACCESS = number of clock cycles after t_adv_eon */
- tmp = (t.oe_on * 1000) + (5 * fclk_ps);
- t.access = next_clk(t.oe_on, tmp, fclk_ps);
-
- /* OE_OFF = after data gets sampled */
- tmp = (t.access * 1000) + (1 * fclk_ps);
- t.oe_off = next_clk(t.access, tmp, fclk_ps);
- t.cs_rd_off = t.oe_off;
-
- tmp = t.cs_rd_off * 1000 + 7000 /* t_scsn_rdy_z */;
- t.rd_cycle = next_clk(t.cs_rd_off, tmp, fclk_ps);
-
- /*
- * WRITE ... based on omap2420 TRM fig 12-21
- */
-
- /* ADV_WR_OFF = t_scsnh_advnh */
- t.adv_wr_off = t.adv_rd_off;
-
- /* WE_ON = t_scsnh_advnh + t_advn_wen * fclk_ps (then wait for nRDY) */
- tmp = (t.adv_wr_off * 1000) + (3 * fclk_ps);
- t.we_on = next_clk(t.adv_wr_off, tmp, fclk_ps);
-
- /* WE_OFF = number of clock cycles after t_adv_wen */
- tmp = (t.we_on * 1000) + (6 * fclk_ps);
- t.we_off = next_clk(t.we_on, tmp, fclk_ps);
-
- t.cs_wr_off = t.we_off;
-
- tmp = t.cs_wr_off * 1000 + 7000 /* t_scsn_rdy_z */;
- t.wr_cycle = next_clk(t.cs_wr_off, tmp, fclk_ps);
-
- t.clk_activation = gpmc_ticks_to_ns(1);
+ memset(&dev_t, 0, sizeof(dev_t));
+
+ dev_t.mux = true;
+ dev_t.sync_read = true;
+ dev_t.sync_write = true;
+
+ dev_t.clk = 11100;
+ dev_t.t_bacc = 1000;
+ dev_t.t_ces = 1000;
+ dev_t.t_ceasu = 8 * 1000;
+ dev_t.t_avdasu = t_scsnh_advnh - 7000;
+ dev_t.t_ce_avd = 1000;
+ dev_t.t_avdp_r = t_scsnh_advnh;
+ dev_t.cyc_aavdh_oe = 3;
+ dev_t.cyc_oe = 5;
+ dev_t.t_ce_rdyz = 7000;
+ dev_t.t_avdp_w = t_scsnh_advnh;
+ dev_t.cyc_aavdh_we = 3;
+ dev_t.cyc_wpl = 6;
+ dev_t.t_ce_rdyz = 7000;
+
+ gpmc_calc_timings(&t, &dev_t);
return gpmc_cs_set_timings(sync_cs, &t);
}
-extern unsigned long gpmc_get_fclk_period(void);
-
/* tusb driver calls this when it changes the chip's clocking */
int tusb6010_platform_retime(unsigned is_refclk)
{
static const char error[] =
KERN_ERR "tusb6010 %s retime error %d\n";
- unsigned fclk_ps = gpmc_get_fclk_period();
unsigned sysclk_ps;
int status;
- if (!refclk_psec || fclk_ps == 0)
+ if (!refclk_psec)
return -ENODEV;
sysclk_ps = is_refclk ? refclk_psec : TUSB6010_OSCCLK_60;
- status = tusb_set_async_mode(sysclk_ps, fclk_ps);
+ status = tusb_set_async_mode(sysclk_ps);
if (status < 0) {
printk(error, "async", status);
goto done;
}
- status = tusb_set_sync_mode(sysclk_ps, fclk_ps);
+ status = tusb_set_sync_mode(sysclk_ps);
if (status < 0)
printk(error, "sync", status);
done:
--
1.7.1
More information about the linux-arm-kernel
mailing list