[PATCH v2 05/22] ARM: LPAE: support 64-bit virt_to_phys patching
Nicolas Pitre
nicolas.pitre at linaro.org
Mon Aug 13 00:03:47 EDT 2012
On Sun, 12 Aug 2012, Cyril Chemparathy wrote:
> On 08/11/12 23:39, Nicolas Pitre wrote:
> > On Fri, 10 Aug 2012, Cyril Chemparathy wrote:
> >
> > > This patch adds support for 64-bit physical addresses in virt_to_phys()
> > > patching. This does not do real 64-bit add/sub, but instead patches in
> > > the
> > > upper 32-bits of the phys_offset directly into the output of virt_to_phys.
> > >
> > > There is no corresponding change on the phys_to_virt() side, because
> > > computations on the upper 32-bits would be discarded anyway.
> > >
> > > Signed-off-by: Cyril Chemparathy <cyril at ti.com>
> > > ---
> > > arch/arm/include/asm/memory.h | 22 ++++++++++++++++++----
> > > arch/arm/kernel/head.S | 4 ++++
> > > arch/arm/kernel/setup.c | 2 +-
> > > 3 files changed, 23 insertions(+), 5 deletions(-)
> > >
> > > diff --git a/arch/arm/include/asm/memory.h b/arch/arm/include/asm/memory.h
> > > index 81e1714..dc5fbf3 100644
> > > --- a/arch/arm/include/asm/memory.h
> > > +++ b/arch/arm/include/asm/memory.h
> > > @@ -154,14 +154,28 @@
> > > #ifdef CONFIG_ARM_PATCH_PHYS_VIRT
> > >
> > > extern unsigned long __pv_offset;
> > > -extern unsigned long __pv_phys_offset;
> > > +extern phys_addr_t __pv_phys_offset;
> > > #define PHYS_OFFSET __virt_to_phys(PAGE_OFFSET)
> > >
> > > static inline phys_addr_t __virt_to_phys(unsigned long x)
> > > {
> > > - unsigned long t;
> > > - early_patch_imm8("add", t, x, __pv_offset, 0);
> > > - return t;
> > > + unsigned long tlo, thi;
> > > +
> > > + early_patch_imm8("add", tlo, x, __pv_offset, 0);
> > > +
> > > +#ifdef CONFIG_ARM_LPAE
> > > + /*
> > > + * On LPAE, we do not _need_ to do 64-bit arithmetic because the high
> > > + * order 32 bits are never changed by the phys-virt offset. We simply
> > > + * patch in the high order physical address bits instead.
> > > + */
> > > +#ifdef __ARMEB__
> > > + early_patch_imm8_mov("mov", thi, __pv_phys_offset, 0);
> > > +#else
> > > + early_patch_imm8_mov("mov", thi, __pv_phys_offset, 4);
> > > +#endif
> > > +#endif
> > > + return (u64)tlo | (u64)thi << 32;
> > > }
> >
> > Hmmm... I'm afraid this is going to be suboptimal when LPAE is not
> > selected.
> >
>
> I understand your concern, but I don't see the sub-optimality. I tested the
> following function with GCC versions 4.3.3 and 4.7. This is after the other
> changes that I mentioned in my previous email, but with the __virt_to_phys()
> code itself unchanged:
>
> phys_addr_t ____test_virt_to_phys(unsigned long addr)
> {
> return __virt_to_phys(addr);
> }
>
> The resulting code in both cases looks like:
>
> <____test_virt_to_phys>:
> b c04f0528
> bx lr
>
> [the branch of course gets patched to an add]
OK. Please add such information and results in your commit log.
> > First of all, you do not need to cast tlo to a u64 in the return value.
> >
>
> True enough.
>
> > Then, I'm not sure if the compiler is smart enough to see that the
> > returned value is a phys_addr_t which can be a u32, and in this case the
> > (u64)thi << 32 is going to be truncated right away, and therefore there
> > is no point in emiting the corresponding instructions.
> >
>
> In this case, it appears to be smart enough. However, I agree that relying on
> compiler smarts is probably not the best thing for us to do.
Well, we do rely on a lot of compiler smarts in the kernel. As long as
sufficiently old compiler versions do get it right then it should be
fine.
> > Furthermore, if LPAE is not defined, then thi never gets initialized and
> > should produce a warning. Did you test compilation of the code with LPAE
> > turned off?
> >
>
> Sure. One of our test platforms is non-LPAE. The compiler does not produce
> warnings on this, and this is consistent across both compiler versions.
That is odd. I still prefer my version nevertheless so to avoid this
potential issue in the future.
> > I'd prefer something like this where more stuff is validated by the
> > compiler:
> >
> > static inline phys_addr_t __virt_to_phys(unsigned long x)
> > {
> > unsigned long tlo, thi;
> > phys_addr_t ret;
> >
> > early_patch_imm8("add", tlo, x, __pv_offset, 0);
> > ret = tlo;
> >
> > if (sizeof(phys_addr_t) > 4) {
> > #ifdef __ARMEB__
> > early_patch_imm8_mov("mov", thi, __pv_phys_offset, 0);
> > #else
> > early_patch_imm8_mov("mov", thi, __pv_phys_offset, 4);
> > #endif
> > ret |= ((u64)thi) << 32;
> > }
> >
> > return ret);
> > }
> >
> > This should let the compiler optimize things whether LPAE is enabledor
> > not while validating both cases.
> >
>
> Agreed on the principal, but more below...
>
>
> I've meanwhile been chasing down another problem - the code generated for the
> LPAE case. The original code resulted in the following:
>
> <____test_virt_to_phys>:
> mov r2, #0
> b c01bc800 # patch: add r1, r0, __pv_offset
> b c01bc810 # patch: mov r0, __phys_offset_high
> orr r2, r2, r1
> mov r3, r0
> mov r1, r3
> mov r0, r2
> bx lr
>
> Yikes! This code does a bunch of futile register shuffling and a pointless or,
> all in the name of generating the result in a 64-bit register-pair from the
> 32-bit halves.
>
> In order to get past this, I tried adding operand qualifiers (R = upper
> 32-bits, Q = lower 32-bits) in the patch macros, in the hope that treating
> these as native 64-bit register pairs would eliminate the need to shuffle them
> around after the inline assembly blocks. This then allows us to implement
> __virt_to_phys() as follows:
>
> static inline phys_addr_t __virt_to_phys(unsigned long x)
> {
> phys_addr_t t;
>
> if (sizeof(t) == 4) {
> t = x;
> early_patch_imm8("add", t, "", t, __pv_offset, 0);
> return t;
> }
>
> /*
> * On LPAE, we do not _need_ to do 64-bit arithmetic because
> * the high order 32 bits are never changed by the phys-virt
> * offset. We simply patch in the high order physical address
> * bits instead.
> *
> * Note: the mov _must_ be first here. From the compiler's
> * perspective, this is the initializer for the variable. The
> * mov itself initializes only the upper half. The subsequent
> * add treats t as a read/write operand and initializes the
> * lower half.
> */
> #ifdef __ARMEB__
> early_patch_imm8_mov("mov", t, "R", __pv_phys_offset, 0);
> #else
> early_patch_imm8_mov("mov", t, "R", __pv_phys_offset, 4);
> #endif
> early_patch_imm8("add", t, "Q", x, __pv_offset, 0);
>
> return t;
> }
>
> With this, we get significantly better looking generated code:
>
> <____test_virt_to_phys>:
> b c01d519c # patch: mov r3, __phys_offset_high
> b c01d51ac # patch: add r2, r0, __phys_offset_high
> mov r0, r2
> mov r1, r3
> bx lr
>
> This is about as far along as I've been able to proceed. I still haven't
> figured out a way to get it to patch in place without an extra register pair.
>
> Overall, this is still a bit too kludgy for my liking. In particular, the
> read/write operand forces add/sub/... users to initialize the result variable.
> I am currently leaning towards adding native support for 64-bit operations in
> the runtime patch code, instead of having to hack around it with 32-bit
> primitives. Better ideas, any one?
The best I've come up with is this:
//typedef unsigned long phys_addr_t;
typedef unsigned long long phys_addr_t;
phys_addr_t __virt_to_phys(unsigned long v)
{
phys_addr_t p;
if (sizeof(phys_addr_t) > 4) {
asm ("add %Q0, %1, #PV_OFFSET" : "=r" (p) : "r" (v));
asm ("mov %R0, #PHYS_HIGHBITS" : "+r" (p));
} else {
asm ("add %0, %1, #PV_OFFSET" : "=r" (p) : "r" (v));
}
return p;
}
The add is done first as this reduce the life span of the v variable.
Because p is listed as an early clobber, then in theory the register
holding v could be used to store the low part of p right away. If you
put the mov first then you can't do that especially on big endian.
It seems that there is no clean way to combine the LPAE and non LPAE
cases.
Nicolas
More information about the linux-arm-kernel
mailing list