[PATCH 2/2] ARM: only build ssi-fiq.S et al if CONFIG_SND_IMX_SOC_PCM_FIQ is selected

[Sascha Hauer]

On Tue, Aug 07, 2012 at 05:45:14PM -0500, Matt Sealey wrote:
> Further to the previous patch, a custom configuration may be used based on the
> imx_v6_v7_defconfig which removes the board depending on the audio driver pulling
> this support code. However, since it is built dependent on CONFIG_SND_IMX_SOC
> it is enabled in the build for all i.MX processors which enable any audio drivers.
> 
> Correct this by only building the SSI FIQ support code when the more specific
> CONFIG_SND_IMX_SOC_PCM_FIQ is enabled. Since it's enabled in the imx_v6_v7_defconfig
> anyway by the Eukrea board, nothing changes using the defconfig, so this is just
> a convenience for people reconfiguring their kernels more sparsely than the default.
> 
> Signed-off-by: Matt Sealey <matt at genesi-usa.com>
> Acked-by: Shawn Guo <shawn.guo at linaro.org>
> ---
>  arch/arm/plat-mxc/Makefile |    2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/arch/arm/plat-mxc/Makefile b/arch/arm/plat-mxc/Makefile
> index 6ac7200..89927f5 100644
> --- a/arch/arm/plat-mxc/Makefile
> +++ b/arch/arm/plat-mxc/Makefile
> @@ -16,7 +16,7 @@ obj-$(CONFIG_MXC_USE_EPIT) += epit.o
>  obj-$(CONFIG_MXC_DEBUG_BOARD) += 3ds_debugboard.o
>  obj-$(CONFIG_CPU_FREQ_IMX)    += cpufreq.o
>  obj-$(CONFIG_CPU_IDLE) += cpuidle.o
> -ifdef CONFIG_SND_IMX_SOC
> +ifdef CONFIG_SND_IMX_SOC_PCM_FIQ
>  obj-y += ssi-fiq.o
>  obj-y += ssi-fiq-ksym.o
>  endif

Since you are here already, better do:

obj-$(CONFIG_SND_IMX_SOC_PCM_FIQ) +) += ssi-fiq.o ssi-fiq-ksym.o

Sascha

-- 
Pengutronix e.K.                           |                             |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |
Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0    |
Amtsgericht Hildesheim, HRA 2686           | Fax:   +49-5121-206917-5555 |