[PATCH 1/6] ARM: mxs: tx28: reset fec phy for device tree boot

[Shawn Guo]

On Mon, Aug 06, 2012 at 01:51:07PM -0300, Otavio Salvador wrote:
> On Mon, Aug 6, 2012 at 12:42 PM, Shawn Guo <shawn.guo at linaro.org> wrote:
> > For non-DT boot, function tx28_add_fec0 configures all ENET0 pins
> > into gpio mode for resetting fec phy, and then reconfigures those pins
> > into ENET function after that.
> >
> > For DT boot, all the pin configuration is done by pinctrl subsystem.
> > Ideally, when gpio_requst gets called, GPIO subsystem should call
> 
>                         ^ typo
> 
Fixed.  Thanks, Otavio.

-- 
Regards,
Shawn