[PATCH v2 2/4] PM / OPP: Initialize OPP table from device tree

[Rob Herring]

On 08/05/2012 10:19 PM, Shawn Guo wrote:
> On Sun, Aug 05, 2012 at 09:50:32PM -0500, Rob Herring wrote:
>>> +Properties:
>>> +- operating-points: An array of 3-tuples items, and each item consists
>>
>> 3 tuples?
>>
> It's the case of v1, and I forgot updating it.  Thanks for spotting it.
> 
>>> +  of frequency and voltage like <freq-kHz vol-uV>.
>>> +	freq: clock frequency in kHz
>>> +	vol: voltage in microvolt
>>
>> Although maybe 3 fields would be good for a flags field? I'm concerned
>> it's a pretty generic name and not very future proof. What about
>> transition times? Not sure how you would represent that as it probably
>> depends on which points you are changing between rather than a property
>> of the opp.
>>
> This is a binding for OPP, which does not define transition times.
> 
> As for cpufreq, we only need to represent a possible maximum transition
> latency.  The driver will ask regulator subsystem for voltage latency,
> while the clock latency is defined in DT. 
> 
>> I think this whole function can be written more concisely. Just iterate
>> over the property and avoid the intermediate array allocation.
>>
> I'm not sure about that, since directly iterating over the property
> means we have to take care of all these sanity checks done in API
> of_property_read_u32_array().
> 

This won't work?:

of_property_for_each_u32(...) {
	if (i & 0x1) {
		volt = val;
		ret = opp_add(dev, freq, volt);
		if (ret)
			...
	} else
		freq = val * 1000;

	i++;
}

Rob