[PATCH 08/22] ARM: LPAE: use phys_addr_t for initrd location and size

[Cyril Chemparathy]

On 8/4/2012 2:57 AM, Nicolas Pitre wrote:
> On Tue, 31 Jul 2012, Cyril Chemparathy wrote:
>
>> From: Vitaly Andrianov <vitalya at ti.com>
>>
>> This patch fixes the initrd setup code to use phys_addr_t instead of assuming
>> 32-bit addressing.  Without this we cannot boot on systems where initrd is
>> located above the 4G physical address limit.
>>
>> Signed-off-by: Vitaly Andrianov <vitalya at ti.com>
>> Signed-off-by: Cyril Chemparathy <cyril at ti.com>
>> ---
>>   arch/arm/mm/init.c |   14 +++++++-------
>>   1 file changed, 7 insertions(+), 7 deletions(-)
>>
>> diff --git a/arch/arm/mm/init.c b/arch/arm/mm/init.c
>> index 8252c31..51f3e92 100644
>> --- a/arch/arm/mm/init.c
>> +++ b/arch/arm/mm/init.c
>> @@ -36,12 +36,12 @@
>>
>>   #include "mm.h"
>>
>> -static unsigned long phys_initrd_start __initdata = 0;
>> -static unsigned long phys_initrd_size __initdata = 0;
>> +static phys_addr_t phys_initrd_start __initdata = 0;
>> +static phys_addr_t phys_initrd_size __initdata = 0;
>
> phys_addr_t for the initrd size is rather overkill, isn't it?
>

Fair enough. :-)

>
> Nicolas
>

-- 
Thanks
- Cyril