[PATCH v3 4/9] GPIO: gpio-pxa: simplify pxa_gpio_to_irq() and pxa_irq_to_chip()

[Haojian Zhuang]

On Sun, Aug 5, 2012 at 8:12 AM, Linus Walleij <linus.walleij at linaro.org> wrote:
> On Sat, Jul 28, 2012 at 12:07 PM, Daniel Mack <zonque at gmail.com> wrote:
>
>> Simplify the code in gpio-pxa.c and make them based on irq_base.
>> When not probed from devicetree, initialize irq_base from
>> PXA_GPIO_TO_IRQ() or MMP_GPIO_TO_IRQ(), respectively, so the non-DT case
>> still works.
>>
>> +#ifdef CONFIG_ARCH_PXA
>> +               if (gpio_is_pxa_type(gpio_type))
>> +                       irq_base = PXA_GPIO_TO_IRQ(0);
>> +#endif
>> +#ifdef CONFIG_ARCH_MMP
>> +               if (gpio_is_mmp_type(gpio_type))
>> +                       irq_base = MMP_GPIO_TO_IRQ(0);
>> +#endif
>
> Grrr. Can we think of a way to get rid of these #ifdef:s?
>

It's used for non-DT mode. This driver is used in both arch-pxa
and arch-mmp. Since we use static irq allocation in non-DT mode,
we have to use this kind of code to get irq_base.

What Daniel did is only simplifying the code.

Regards
Haojian