[PATCH v3 2/3] ARM: OMAP: TI814X: Add cpu type macros and detection support
Pedanekar, Hemant
hemantp at ti.com
Fri Sep 30 20:54:29 EDT 2011
Hi Paul,
Paul Walmsley wrote on Friday, September 30, 2011 2:17 AM:
> Hello Hemant,
>
> a few comments:
>
> On Thu, 29 Sep 2011, Hemant Pedanekar wrote:
>
>> This patch adds cpu type, macros for identification of TI814X device.
>>
>> Note that following update to common OMAP data structures is made:
>>
>> cpu_mask and RATE_IN_XXX flags have crossed 8 bit hence struct
>> clksel_rate.flags, struct prcm_config.flags and cpu_mask are changed to
>> u16 from u8.
>>
>> Signed-off-by: Hemant Pedanekar <hemantp at ti.com>
>
> Also, the opp2xxx.h change looks spurious, is that really needed?
>
I changed prcm_config.flags to accommodate cpu_mask change, as cpu_mask
is used with prcm_config.flags (mostly) in clkt2xxx_virt_prcm_set.c as
below:
prcm->flags & cpu_mask
And flags is assigned in opp2420_data.c (e.g., RATE_IN_242X)
But yes, these are already defined RATE_INs and do not cross 8-bits,
so no warnings even if flags is 8-bit and cpu_mask changed to 16-bit.
What is your suggestion?
I see you mentioned "Also" in the above comment, but didn't see any
comment preceeding.
> Could you please split the clock-related changes into a
> separate patch?
> Then this patch would just be the id.c and cpu.h changes.
>
> Other than that, the patch looks okay to me.
>
>
> - Paul
Will do that.
Thanks.
Hemant
More information about the linux-arm-kernel
mailing list