[PATCH v2 0/5] OMAP3EVM: Add support for MT9T111 sensor

[Deepthy Ravi]

This patchset
	-adds support for MT9T111 sensor on omap3evm.
	Currently the sensor driver supports only
	VGA resolution.
	-enables MT9T111 sensor in omap2plus_defconfig.

This is dependent on the following patchset
http://www.spinics.net/lists/linux-media/msg37270.html 
which adds YUYV input support for OMAP3ISP. And is 
applied on top of rc1-for-3.2 of gliakhovetski/v4l-dvb.git
---
Changes in v2:
	As per the discussion here,
	https://lkml.org/lkml/2011/9/20/280
	the existing mt9t112 driver is reused for
	adding support for mt9t111 sensor.
Deepthy Ravi (3):
  [media] v4l: Add support for mt9t111 sensor driver
  ispccdc: Configure CCDC_SYN_MODE register
  omap2plus_defconfig: Enable omap3isp and MT9T111 sensor drivers

Vaibhav Hiremath (2):
  omap3evm: Enable regulators for camera interface
  omap3evm: Add Camera board init/hookup file

 arch/arm/configs/omap2plus_defconfig        |    9 +
 arch/arm/mach-omap2/Makefile                |    5 +
 arch/arm/mach-omap2/board-omap3evm-camera.c |  185 ++++
 arch/arm/mach-omap2/board-omap3evm.c        |   26 +
 drivers/media/video/Kconfig                 |    7 +
 drivers/media/video/Makefile                |    1 +
 drivers/media/video/mt9t111_reg.h           | 1367 +++++++++++++++++++++++++++
 drivers/media/video/mt9t112.c               |  320 ++++++-
 drivers/media/video/omap3isp/ispccdc.c      |   11 +-
 include/media/mt9t111.h                     |   45 +
 10 files changed, 1937 insertions(+), 39 deletions(-)
 create mode 100644 arch/arm/mach-omap2/board-omap3evm-camera.c
 create mode 100644 drivers/media/video/mt9t111_reg.h
 create mode 100644 include/media/mt9t111.h