[PATCH v2 4/7] clk: Add simple gated clock

Jamie Iles jamie at jamieiles.com
Mon Sep 26 15:37:33 EDT 2011


On Mon, Sep 26, 2011 at 02:10:32PM -0500, Rob Herring wrote:
> On 09/26/2011 01:40 PM, Jamie Iles wrote:
> > On Mon, Sep 26, 2011 at 01:33:08PM -0500, Rob Herring wrote:
> >>> +static void clk_gate_set_bit(struct clk_hw *clk)
> >>> +{
> >>> +	struct clk_gate *gate = to_clk_gate(clk);
> >>> +	u32 reg;
> >>> +
> >>> +	reg = __raw_readl(gate->reg);
> >>> +	reg |= BIT(gate->bit_idx);
> >>> +	__raw_writel(reg, gate->reg);
> >>
> >> Don't these read-mod-writes need a spinlock around it?
> >>
> >> It's possible to have an enable bits and dividers in the same register.
> >> If you did a set_rate and while doing an enable/disable, there would be
> >> a problem. Also, it may be 2 different clocks in the same register, so
> >> the spinlock needs to be shared and not per clock.
> > 
> > Well the prepare lock will be held here and I believe that would be 
> > sufficient.
> 
> No, the enable spinlock is protecting enable/disable. But set_rate is
> protected by the prepare mutex. So you clearly don't need locking if you
> have a register of only 1 bit enables. If you have a register accessed
> by both enable/disable and prepare/unprepare/set_rate, then you need
> some protection.

OK fair point, but I would guess that if you had a clock like this then 
you probably wouldn't use this simple gated clock would you?  (speaking 
from my world where we have quite simple clocks ;-))

Jamie



More information about the linux-arm-kernel mailing list