[PATCH 09/11] at92/ohci: use gpio_is_valid to check the gpio
Jean-Christophe PLAGNIOL-VILLARD
plagnioj at jcrosoft.com
Mon Sep 19 10:03:20 EDT 2011
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
Cc: Nicolas Ferre <nicolas.ferre at atmel.com>
Cc: linux-usb at vger.kernel.org
---
Hi,
I'd like to apply this patch via AT91 with the whole gpio patch series
Best Regards,
J.
drivers/usb/host/ohci-at91.c | 4 ++--
1 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/usb/host/ohci-at91.c b/drivers/usb/host/ohci-at91.c
index e08cb10..70701f4 100644
--- a/drivers/usb/host/ohci-at91.c
+++ b/drivers/usb/host/ohci-at91.c
@@ -276,7 +276,7 @@ static int ohci_hcd_at91_drv_probe(struct platform_device *pdev)
* active-low power switches.
*/
for (i = 0; i < ARRAY_SIZE(pdata->vbus_pin); i++) {
- if (pdata->vbus_pin[i] <= 0)
+ if (!gpio_is_valid(pdata->vbus_pin[i]))
continue;
gpio_request(pdata->vbus_pin[i], "ohci_vbus");
gpio_direction_output(pdata->vbus_pin[i], 0);
@@ -294,7 +294,7 @@ static int ohci_hcd_at91_drv_remove(struct platform_device *pdev)
if (pdata) {
for (i = 0; i < ARRAY_SIZE(pdata->vbus_pin); i++) {
- if (pdata->vbus_pin[i] <= 0)
+ if (!gpio_is_valid(pdata->vbus_pin[i]))
continue;
gpio_direction_output(pdata->vbus_pin[i], 1);
gpio_free(pdata->vbus_pin[i]);
--
1.7.5.4
More information about the linux-arm-kernel
mailing list