[PATCH 05/11] at91/ide: use gpio_is_valid to check the gpio
Jean-Christophe PLAGNIOL-VILLARD
plagnioj at jcrosoft.com
Mon Sep 19 08:51:29 EDT 2011
Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
Cc: Nicolas Ferre <nicolas.ferre at atmel.com>
Cc: linux-ide at vger.kernel.org
---
Hi,
I'd like to apply this patch via AT91 with the whole gpio patch series
Best Regards,
J.
drivers/ide/at91_ide.c | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/drivers/ide/at91_ide.c b/drivers/ide/at91_ide.c
index 000a78e..ba2eda3 100644
--- a/drivers/ide/at91_ide.c
+++ b/drivers/ide/at91_ide.c
@@ -314,7 +314,7 @@ static int __init at91_ide_probe(struct platform_device *pdev)
apply_timings(board->chipselect, 0, ide_timing_find_mode(XFER_PIO_0), 0);
/* with GPIO interrupt we have to do quirks in handler */
- if (board->irq_pin >= PIN_BASE)
+ if (gpio_is_valid(board->irq_pin))
host->irq_handler = at91_irq_handler;
host->ports[0]->select_data = board->chipselect;
--
1.7.5.4
More information about the linux-arm-kernel
mailing list