[PATCH v2] arm: omap3evm: Add support for an MT9M032 based camera board.

[Joe Perches]

On Sat, 2011-09-17 at 11:34 +0200, Martin Hostettler wrote:
> Adds board support for an MT9M032 based camera to omap3evm.

All of the logging messages could be
prefixed by the printk subsystem if you
add #define pr_fmt before any #include

> diff --git a/arch/arm/mach-omap2/board-omap3evm-camera.c b/arch/arm/mach-omap2/board-omap3evm-camera.c
[]
#define pr_fmt(fmt) KBUILD_MODNAME ": " fmt
[]
> +static int omap3evm_set_mux(enum omap3evmdc_mux mux_id)
[]
> +	switch (mux_id) {
[]
> +	default:
> +		pr_err("omap3evm-camera: Invalid mux id #%d\n", mux_id);

		pr_err("Invalid mux id #%d\n", mux_id);
[]
> +static int __init camera_init(void)
[]
> +	if (gpio_request(nCAM_VD_SEL, "nCAM_VD_SEL") < 0) {
> +		pr_err("omap3evm-camera: Failed to get GPIO nCAM_VD_SEL(%d)\n",
> +		       nCAM_VD_SEL);

		pr_err("Failed to get GPIO nCAM_VD_SEL(%d)\n",
		       nCAM_VD_SEL);
etc.