[PATCH 1/3] ARM: debug: use kconfig choice for selecting DEBUG_LL UART

Stephen Boyd sboyd at codeaurora.org
Thu Sep 15 13:34:27 EDT 2011


On 08/16/11 14:41, Will Deacon wrote:
> +choice
> +	prompt "Kernel low-level debugging port"
> +	depends on DEBUG_LL
> +
> +	config DEBUG_DC21285_PORT
> +		bool "Kernel low-level debugging messages via footbridge serial port"
> +		depends on FOOTBRIDGE
> +		help
> +		  Say Y here if you want the debug print routines to direct
> +		  their output to the serial port in the DC21285 (Footbridge).
> +		  Saying N will cause the debug messages to appear on the first
> +		  16550 serial port.
> +
> +	config DEBUG_CLPS711X_UART2
> +		bool "Kernel low-level debugging messages via UART2"
> +		depends on ARCH_CLPS711X
> +		help
> +		  Say Y here if you want the debug print routines to direct
> +		  their output to the second serial port on these devices.
> +		  Saying N will cause the debug messages to appear on the first
> +		  serial port.

How would I unselect this UART2 config to get serial output on UART1? As
far as I can tell there isn't an option for NONE in a choice menu.

-- 
Sent by an employee of the Qualcomm Innovation Center, Inc.
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum.




More information about the linux-arm-kernel mailing list