[PATCH v7 24/26] gpio/omap: restore OE only after setting the output level
Tarun Kanti DebBarma
tarun.kanti at ti.com
Tue Sep 13 09:02:57 EDT 2011
From: Nishanth Menon <nm at ti.com>
Setup the dataout register before restoring OE. This is to make
sure that we have valid data in dataout register which would be
made available in output pins as soon as OE is enabled. Else,
there is risk of unknown data getting out into gpio pins.
Signed-off-by: Nishanth Menon <nm at ti.com>
Signed-off-by: Tarun Kanti DebBarma <tarun.kanti at ti.com>
Reviewed-by: Santosh Shilimkar <santosh.shilimkar at ti.com>
---
drivers/gpio/gpio-omap.c | 3 ++-
1 files changed, 2 insertions(+), 1 deletions(-)
diff --git a/drivers/gpio/gpio-omap.c b/drivers/gpio/gpio-omap.c
index 4687d6b..165a598 100644
--- a/drivers/gpio/gpio-omap.c
+++ b/drivers/gpio/gpio-omap.c
@@ -1313,7 +1313,6 @@ static void omap_gpio_restore_context(struct gpio_bank *bank)
__raw_writel(bank->context.wake_en,
bank->base + bank->regs->wkup_en);
__raw_writel(bank->context.ctrl, bank->base + bank->regs->ctrl);
- __raw_writel(bank->context.oe, bank->base + bank->regs->direction);
__raw_writel(bank->context.leveldetect0,
bank->base + bank->regs->leveldetect0);
__raw_writel(bank->context.leveldetect1,
@@ -1323,6 +1322,8 @@ static void omap_gpio_restore_context(struct gpio_bank *bank)
__raw_writel(bank->context.fallingdetect,
bank->base + bank->regs->fallingdetect);
__raw_writel(bank->context.dataout, bank->base + bank->regs->dataout);
+ __raw_writel(bank->context.oe, bank->base + bank->regs->direction);
+
if (bank->dbck_enable_mask) {
__raw_writel(bank->context.debounce, bank->base +
bank->regs->debounce);
--
1.7.0.4
More information about the linux-arm-kernel
mailing list