[RFC PATCH 06/10] hwspinlock: OMAP4: Add spinlock support in DT

[Cousson, Benoit]

On 9/8/2011 4:47 PM, Arnd Bergmann wrote:
> On Thursday 08 September 2011, Ohad Ben-Cohen wrote:
>> On Thu, Sep 8, 2011 at 11:07 AM, Cousson, Benoit<b-cousson at ti.com>  wrote:
>>> The (small) issue for my point of view is that the #hwspinlock is already
>>> encoded in the IP itself. So adding a baseid directly in DT will look like
>>> duplicating indirectly something that is already there in the HW.
>>> That being said, since we cannot rely on the order, we will not be able to
>>> get the proper baseid until the driver probe every hwspinlock devices :-(
>>> So baseid might be a easier choice.
>>
>> Sounds good. Thanks a lot !
>
> I think a number would work here but is not optimal for the device tree
> representation. I think a better binding would be to encode it like
> interrupt numbers, where every device that uses a hwspinlock will describe
> that as a combination of phandle to the hwspinlock controller and
> identifier to be used by that controller, e.g.
>
> 	spinlock1 {
> 		compatible = "ti,omap-spinlock";
> 		regs = ...
> 		interrupts =<42>;
> 		interrupt-parent =&irq-controller;
> 	};
>
> 	dsp {
> 		compatible = ...
> 		regs = ...
> 		spinlocks =<23>; // local number withing&spinlock1;
> 		spinlock-controller =&spinlock1;
> 	};

OK, this is indeed much more aligned with the current practice, and what 
DMA should do as well.

Practically speaking, that change will go beyond the original scope of 
that patch that was just adding the DT support based on the existing 
functionality.

Is it OK to handle that improvement in a further patch / series?

Thanks,
Benoit