[PATCH] arm: exynos4: fix incorrect pad configuration for keypad row lines
Thomas Abraham
thomas.abraham at linaro.org
Sun Sep 4 05:40:44 EDT 2011
The keypad controller requires a external pull-up for all the keypad
row lines. Fix the incorrect pad configuration for keypad controller
row lines by enabling the pad pull-up for the all row lines of the
keypad controller.
Signed-off-by: Thomas Abraham <thomas.abraham at linaro.org>
---
SMDKV310 board does not have pull-up resistors populated for the keypad
row lines (unlike the smdk boards for the previous Samsung SoC's). So
the pad pull-up for all keypad row lines should be enabled for
smdkv310 board.
The default requirement for the keypad controller is to enable the
pull-up for all the keypad row lines. If a exynos4 based board has
on-board pull-up's populated for keypad row lines, this patch would
cause no harm. And in such cases, if internal pad pull-up is to be
disabled (to reduce some power consumption), an alternative gpio
configuration function can be supplied that does not enable the
internal pad pull-up.
---
arch/arm/mach-exynos4/setup-keypad.c | 11 ++++++-----
1 files changed, 6 insertions(+), 5 deletions(-)
diff --git a/arch/arm/mach-exynos4/setup-keypad.c b/arch/arm/mach-exynos4/setup-keypad.c
index 1ee0ebf..7862bfb 100644
--- a/arch/arm/mach-exynos4/setup-keypad.c
+++ b/arch/arm/mach-exynos4/setup-keypad.c
@@ -19,15 +19,16 @@ void samsung_keypad_cfg_gpio(unsigned int rows, unsigned int cols)
if (rows > 8) {
/* Set all the necessary GPX2 pins: KP_ROW[0~7] */
- s3c_gpio_cfgrange_nopull(EXYNOS4_GPX2(0), 8, S3C_GPIO_SFN(3));
+ s3c_gpio_cfgall_range(EXYNOS4_GPX2(0), 8, S3C_GPIO_SFN(3),
+ S3C_GPIO_PULL_UP);
/* Set all the necessary GPX3 pins: KP_ROW[8~] */
- s3c_gpio_cfgrange_nopull(EXYNOS4_GPX3(0), (rows - 8),
- S3C_GPIO_SFN(3));
+ s3c_gpio_cfgall_range(EXYNOS4_GPX3(0), (rows - 8),
+ S3C_GPIO_SFN(3), S3C_GPIO_PULL_UP);
} else {
/* Set all the necessary GPX2 pins: KP_ROW[x] */
- s3c_gpio_cfgrange_nopull(EXYNOS4_GPX2(0), rows,
- S3C_GPIO_SFN(3));
+ s3c_gpio_cfgall_range(EXYNOS4_GPX2(0), rows, S3C_GPIO_SFN(3),
+ S3C_GPIO_PULL_UP);
}
/* Set all the necessary GPX1 pins to special-function 3: KP_COL[x] */
--
1.6.6.rc2
More information about the linux-arm-kernel
mailing list