[PATCH] at91_ether: use gpio_is_valid for phy IRQ line

[David Miller]

From: Jean-Christophe PLAGNIOL-VILLARD <plagnioj at jcrosoft.com>
Date: Wed, 30 Nov 2011 05:44:03 +0100

> On 18:53 Tue 29 Nov     , David Miller wrote:
>> From: Nicolas Ferre <nicolas.ferre at atmel.com>
>> Date: Thu, 24 Nov 2011 22:21:14 +0100
>> 
>> > Use the generic gpiolib gpio_is_valid() function to test
>> > if the phy IRQ line GPIO is actually provided.
>> > 
>> > For non-connected or non-existing phy IRQ lines, -EINVAL
>> > value is used for phy_irq_pin field of struct at91_eth_data.
>> > 
>> > Signed-off-by: Nicolas Ferre <nicolas.ferre at atmel.com>
>> 
>> I'm assuming this goes through the ARM tree, because in both of my networking
>> trees there is no ARM at91 implementation of gpio_is_valid().
> yes the depending patch series is in the arm-soc
> 
> can we have your ack or sob?

Acked-by: David S. Miller <davem at davemloft.net>