[patch 1/1] kirkwood: Add configuration for MPP12 as GPIO

[Nicolas Pitre]

On Tue, 29 Nov 2011, Arnaud Patard wrote:

> The MPP12 is listed in the 6281 HW manual as output only but the iconnect
> board from iomega is using it as GPIO (there's a button connected on it). So,
> I'm adding a definition for the MPP12 as GPIO. As I've no informations about
> this and which kirkwood are "affected", I'm adding a new #define instead of
> modifying the current one for MPP12.

In that case, please adjust the bitfield  in your definition so it is 
valid only for 
the 6281.


Nicolas