[PATCH v8 17/20] OMAP2+: UART: Use custom activate func for console uart.

[Govindraj]

On Mon, Nov 21, 2011 at 7:17 PM, Govindraj <govindraj.ti at gmail.com> wrote:
> On Sat, Nov 19, 2011 at 2:54 AM, Kevin Hilman <khilman at ti.com> wrote:
>> "Govindraj.R" <govindraj.raja at ti.com> writes:
>>
>>> Omap-uart can be used as console uart to print early boot
>>> messages using earlyprintk so for console uart prevent
>>> hwmod reset or idling during bootup.
>>>
>>> Identify the console_uart set the id and use the custom
>>> pm_latency ops for console uart for the first time
>>> to idle console uart left enabled from bootup and then enable
>>> them back and reset pm_latency ops to default ops.
>>>
>>> Thanks to Kevin Hilman <khilman at ti.com> for suggesting
>>> this approach.
>>
>> You're welcome, but Rajendra's solution is much better. ;)
>
> Agree.
>
>>
>> Can you updated your branch without these custom hooks and using
>> Rajendra's INIT_NO_IDLE change to the hwmod core.
>>
>
> Yes done, rebased on 3.2-rc2 and created a new branch [1].
>
> Removed custom activate function usage and used Rajendra's hwmod patch[2]
>
> --
> Thanks,
> Govindraj.R
>
> [1]:
> git://gitorious.org/runtime_3-0/runtime_3-0.git
> 3.2-rc1_uart_runtime
   ^^^^^^^^^^^^^^^^^^^^^^^^^

small correction new branch is
3.2-rc2_uart_runtime

--
Thanks,
Govindraj.R