[PATCH v3 0/8] Add support for tegra30 and cardhu

[Stephen Warren]

Peter De Schrijver wrote at Monday, November 07, 2011 7:20 AM:
> This patchset adds support for the tegra30 SoC and the cardhu development
> board.
> 
> Pathset is on top of Will Deacon's ARM reset work.

A few minor issues:

1) If I enable just ARCH_TEGRA_3x_SOC, but not ARCH_TEGRA_2x_SOC, the
kernel fails to build because arch/arm/mach-tegra/include/mach/irqs.h
only defines NR_IRQS if ARCH_TEGRA_2x_SOC is defined.

2) All the Tegra20 boards don't depend on ARCH_TEGRA_2x_SOC, so they can
be enabled even if only Tegra30 support is enabled.

3) I notice that in "arm/tegra: pinmux tables and definitions for tegra30",
you ifdef'd the two entries in tegra_pinmux_of_match[] based on which SoCs
were enabled, but in "arm/tegra: implement support for tegra30", you didn't
do the same for the two entries in early_init[] (board-dt.c). I'm not sure
how far we want to take only-Tegra20 or only-Tegra30 support, but perhaps
we should be consistent here?

I've tested this series on Harmony both booting with a board file and booting
using device-tree and don't see any issues. I'll try to test it on Cardhu
later today.

-- 
nvpublic