[PATCH 5/6] mmc: Add OF bindings support for mmc host controller capabilities

[Olof Johansson]

On Thu, Nov 03, 2011 at 02:06:02AM +0530, Thomas Abraham wrote:
> Device nodes representing sd/mmc controllers in a device tree would include
> mmc host controller capabilities. Add support for parsing of mmc host
> controller capabilities included in device nodes.
> 
> Signed-off-by: Thomas Abraham <thomas.abraham at linaro.org>
> ---
>  .../devicetree/bindings/mmc/linux-mmc-host.txt     |   13 ++++++++
>  drivers/mmc/core/host.c                            |   31 ++++++++++++++++++++
>  include/linux/mmc/host.h                           |    1 +
>  3 files changed, 45 insertions(+), 0 deletions(-)
>  create mode 100644 Documentation/devicetree/bindings/mmc/linux-mmc-host.txt
> 
> diff --git a/Documentation/devicetree/bindings/mmc/linux-mmc-host.txt b/Documentation/devicetree/bindings/mmc/linux-mmc-host.txt
> new file mode 100644
> index 0000000..714b2b1
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/mmc/linux-mmc-host.txt
> @@ -0,0 +1,13 @@
> +* Linux MMC Host Controller Capabilities
> +
> +The following bindings can be used in a device node to specify any board
> +specific mmc host controller capabilities.
> +
> +- linux,mmc_cap_4_bit_data - Host can do 4-bit transfers
> +- linux,mmc_cap_mmc_highspeed - Host can do MMC high-speed timing
> +- linux,mmc_cap_sd_highspeed - Host can do SD high-speed timing
> +- linux,mmc_cap_needs_poll - Host needs polling for card detection
> +- linux,mmc_cap_8_bit_data - Host can do 8-bit transfer
> +- linux,mmc_cap_disable - Host can be disabled and re-enabled to save power
> +- linux,mmc_cap_nonremovable - Host is connected to nonremovable media
> +- linux,mmc_cap_erase - Host allows erase/trim commands

linux-prefixed properties are a big red flag. The device tree should describe
the hardware, not what linux does with the hardware.

See previous comments about "support-8bit" for encoding exactly the same
hardware capability in a linux-agnostic way. What the sdhci driver chooses to
do with it is up to the driver, and in some cases it means it will set the
capabilities flag.

Same goes for the other properties. It should not go in as it is
implemented in this patch, it needs to be fixed up.


-Olof