[PATCH v2 1/2] arm/dt: add basic usb nodes to tegra device trees
Olof Johansson
olof at lixom.net
Fri Nov 4 15:12:39 EDT 2011
For now they are a minimal binding. It needs to be amended with
vendor-specific settings for phy setup and link tuning, etc.
v2: Added bindings specification and phy_type properties
Signed-off-by: Olof Johansson <olof at lixom.net>
Acked-by: Grant Likely <grant.likely at secretlab.ca>
---
.../devicetree/bindings/usb/tegra-usb.txt | 13 ++++++++++++
arch/arm/boot/dts/tegra-seaboard.dts | 4 +++
arch/arm/boot/dts/tegra20.dtsi | 21 ++++++++++++++++++++
3 files changed, 38 insertions(+), 0 deletions(-)
create mode 100644 Documentation/devicetree/bindings/usb/tegra-usb.txt
diff --git a/Documentation/devicetree/bindings/usb/tegra-usb.txt b/Documentation/devicetree/bindings/usb/tegra-usb.txt
new file mode 100644
index 0000000..035d63d
--- /dev/null
+++ b/Documentation/devicetree/bindings/usb/tegra-usb.txt
@@ -0,0 +1,13 @@
+Tegra SOC USB controllers
+
+The device node for a USB controller that is part of a Tegra
+SOC is as described in the document "Open Firmware Recommended
+Practice : Universal Serial Bus" with the following modifications
+and additions :
+
+Required properties :
+ - compatible : Should be "nvidia,tegra20-ehci" for USB controllers
+ used in host mode.
+ - phy_type : Should be one of "ulpi" or "utmi".
+ - nvidia,vbus-gpio : If present, specifies a gpio that needs to be
+ activated for the bus to be powered.
diff --git a/arch/arm/boot/dts/tegra-seaboard.dts b/arch/arm/boot/dts/tegra-seaboard.dts
index a72299b..88c682a 100644
--- a/arch/arm/boot/dts/tegra-seaboard.dts
+++ b/arch/arm/boot/dts/tegra-seaboard.dts
@@ -29,4 +29,8 @@
sdhci at c8000600 {
support-8bit;
};
+
+ usb at c5000000 {
+ nvidia,vbus-gpio = <&gpio 24 0>; /* PD0 */
+ };
};
diff --git a/arch/arm/boot/dts/tegra20.dtsi b/arch/arm/boot/dts/tegra20.dtsi
index 65d7e6a..795b921 100644
--- a/arch/arm/boot/dts/tegra20.dtsi
+++ b/arch/arm/boot/dts/tegra20.dtsi
@@ -143,5 +143,26 @@
reg = <0xc8000600 0x200>;
interrupts = < 63 >;
};
+
+ usb at c5000000 {
+ compatible = "nvidia,tegra20-ehci", "usb-ehci";
+ reg = <0xc5000000 0x4000>;
+ interrupts = < 52 >;
+ phy_type = "utmi";
+ };
+
+ usb at c5004000 {
+ compatible = "nvidia,tegra20-ehci", "usb-ehci";
+ reg = <0xc5004000 0x4000>;
+ interrupts = < 53 >;
+ phy_type = "ulpi";
+ };
+
+ usb at c5008000 {
+ compatible = "nvidia,tegra20-ehci", "usb-ehci";
+ reg = <0xc5008000 0x4000>;
+ interrupts = < 129 >;
+ phy_type = "utmi";
+ };
};
--
1.7.4.1
More information about the linux-arm-kernel
mailing list