[PATCH] arm: omap3: cm-t35: add support for cm-t3730
Mike Rapoport
mike at compulab.co.il
Thu May 5 05:51:19 EDT 2011
On 05/05/11 11:53, Igor Grinberg wrote:
> cm-t3730 is basically the same board as cm-t35, but has DM3730 SoC
> assembled and therefore some changes are required.
>
> Signed-off-by: Igor Grinberg <grinberg at compulab.co.il>
> ---
> arch/arm/mach-omap2/Kconfig | 2 +-
> arch/arm/mach-omap2/board-cm-t35.c | 62 +++++++++++++++++++++++++++---------
> 2 files changed, 48 insertions(+), 16 deletions(-)
Acked-by: Mike Rapoport <mike at compulab.co.il>
>
> diff --git a/arch/arm/mach-omap2/Kconfig b/arch/arm/mach-omap2/Kconfig
> index b997a35..920b6bc 100644
> --- a/arch/arm/mach-omap2/Kconfig
> +++ b/arch/arm/mach-omap2/Kconfig
> @@ -266,7 +266,7 @@ config MACH_OMAP_ZOOM3
> select REGULATOR_FIXED_VOLTAGE
>
> config MACH_CM_T35
> - bool "CompuLab CM-T35 module"
> + bool "CompuLab CM-T35/CM-T3730 modules"
> depends on ARCH_OMAP3
> default y
> select OMAP_PACKAGE_CUS
> diff --git a/arch/arm/mach-omap2/board-cm-t35.c b/arch/arm/mach-omap2/board-cm-t35.c
> index 6063be8..c0f6ce0 100644
> --- a/arch/arm/mach-omap2/board-cm-t35.c
> +++ b/arch/arm/mach-omap2/board-cm-t35.c
> @@ -524,7 +524,7 @@ static void __init cm_t35_init_early(void)
> }
>
> #ifdef CONFIG_OMAP_MUX
> -static struct omap_board_mux board_mux[] __initdata = {
> +static struct omap_board_mux cm_t35_common_board_mux[] __initdata = {
> /* nCS and IRQ for CM-T35 ethernet */
> OMAP3_MUX(GPMC_NCS5, OMAP_MUX_MODE0),
> OMAP3_MUX(UART3_CTS_RCTX, OMAP_MUX_MODE4 | OMAP_PIN_INPUT_PULLUP),
> @@ -580,17 +580,12 @@ static struct omap_board_mux board_mux[] __initdata = {
> OMAP3_MUX(UART1_TX, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> OMAP3_MUX(UART1_RX, OMAP_MUX_MODE0 | OMAP_PIN_INPUT),
>
> - /* DSS */
> + /* common DSS */
> OMAP3_MUX(DSS_PCLK, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> OMAP3_MUX(DSS_HSYNC, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> OMAP3_MUX(DSS_VSYNC, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> OMAP3_MUX(DSS_ACBIAS, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA0, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA1, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA2, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA3, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA4, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA5, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> +
> OMAP3_MUX(DSS_DATA6, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> OMAP3_MUX(DSS_DATA7, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> OMAP3_MUX(DSS_DATA8, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> @@ -603,12 +598,6 @@ static struct omap_board_mux board_mux[] __initdata = {
> OMAP3_MUX(DSS_DATA15, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> OMAP3_MUX(DSS_DATA16, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> OMAP3_MUX(DSS_DATA17, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA18, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA19, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA20, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA21, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA22, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
> - OMAP3_MUX(DSS_DATA23, OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT),
>
> /* display controls */
> OMAP3_MUX(MCBSP1_FSR, OMAP_MUX_MODE4 | OMAP_PIN_OUTPUT),
> @@ -621,6 +610,39 @@ static struct omap_board_mux board_mux[] __initdata = {
>
> { .reg_offset = OMAP_MUX_TERMINATOR },
> };
> +
> +static void cm_t35_mux_init(void)
> +{
> + int mux_mode = OMAP_MUX_MODE0 | OMAP_PIN_OUTPUT;
> +
> + omap3_mux_init(cm_t35_common_board_mux, OMAP_PACKAGE_CUS);
> +
> + if (cpu_is_omap34xx()) {
> + omap_mux_init_signal("gpio_70", mux_mode);
> + omap_mux_init_signal("gpio_71", mux_mode);
> + omap_mux_init_signal("gpio_72", mux_mode);
> + omap_mux_init_signal("gpio_73", mux_mode);
> + omap_mux_init_signal("gpio_74", mux_mode);
> + omap_mux_init_signal("gpio_75", mux_mode);
> + } else if (cpu_is_omap3630()) {
> + mux_mode = OMAP_MUX_MODE3 | OMAP_PIN_OUTPUT;
> + omap_mux_init_signal("sys_boot0", mux_mode);
> + omap_mux_init_signal("sys_boot1", mux_mode);
> + omap_mux_init_signal("sys_boot3", mux_mode);
> + omap_mux_init_signal("sys_boot4", mux_mode);
> + omap_mux_init_signal("sys_boot5", mux_mode);
> + omap_mux_init_signal("sys_boot6", mux_mode);
> + }
> +
> + omap_mux_init_signal("dss_data18", mux_mode);
> + omap_mux_init_signal("dss_data19", mux_mode);
> + omap_mux_init_signal("dss_data20", mux_mode);
> + omap_mux_init_signal("dss_data21", mux_mode);
> + omap_mux_init_signal("dss_data22", mux_mode);
> + omap_mux_init_signal("dss_data23", mux_mode);
> +}
> +#else
> +static inline void cm_t35_mux_init(void) {}
> #endif
>
> static struct omap_board_config_kernel cm_t35_config[] __initdata = {
> @@ -630,7 +652,7 @@ static void __init cm_t35_init(void)
> {
> omap_board_config = cm_t35_config;
> omap_board_config_size = ARRAY_SIZE(cm_t35_config);
> - omap3_mux_init(board_mux, OMAP_PACKAGE_CUS);
> + cm_t35_mux_init();
> omap_serial_init();
> cm_t35_init_i2c();
> cm_t35_init_nand();
> @@ -652,3 +674,13 @@ MACHINE_START(CM_T35, "Compulab CM-T35")
> .init_machine = cm_t35_init,
> .timer = &omap_timer,
> MACHINE_END
> +
> +MACHINE_START(CM_T3730, "Compulab CM-T3730")
> + .boot_params = 0x80000100,
> + .reserve = omap_reserve,
> + .map_io = omap3_map_io,
> + .init_early = cm_t35_init_early,
> + .init_irq = omap_init_irq,
> + .init_machine = cm_t35_init,
> + .timer = &omap_timer,
> +MACHINE_END
--
Sincerely yours,
Mike.
More information about the linux-arm-kernel
mailing list