[PATCH v4 1/1] can: add pruss CAN driver.

[Wolfgang Grandegger]

Hi Arnd,

On 05/04/2011 03:11 PM, Arnd Bergmann wrote:
> On Wednesday 04 May 2011, Subhasish Ghosh wrote:
>> CAN requires mail box IDs to be programmed in. But, the socket
>> CAN subsystem supports only software filtering of the mail box IDs.
>>
>> So, the mail box IDs programmed into socket CAN during initialization
>> does not propagate into the hardware. This is planned to be a future
>> implementation in Socket CAN.
>>
>> In our case, we support hardware filtering, to work around with this,
>> Wolfgang (Socket CAN owner) suggested that we implement
>> this using sysfs.
>>
>> These setting are not for debugging, but to program the mail box IDs
>> into the hardware. 
> 
> Ok, I see. Can you point me to that discussion?
> 
> Wolfgang, I'm a bit worried by the API being split between sockets and sysfs.
> The problem is that once the sysfs API is established, users will start
> relying on it, and you can no longer migrate away from it, even when
> a later version of the Socket CAN also supports setting through a different
> interface. What is the current interface to set mail box IDs in software?

Note that this CAN controller is *very* special. It cannot handle all
CAN id's due to a lack or resources. The PRUSS firmware is able to
manage just up to 8 different CAN identifiers out of the usual 4096
(12-bit) or even more for the extended CAN ids using 29 bits. There is
no other CAN controller with such rather serious limitations and
therefore there exists also no appropriate interface. I think using
sysfs is OK for such device-specific parameters, at least for the time
being.

> How hard would it be to implement that feature in Socket CAN?

CAN controllers usually provide some kind of hardware CAN id filtering,
but in a very hardware dependent way. A generic interface may be able to
handle the PRUSS restrictions as well. CAN devices are usually
configured through the netlink interface. e.g.

  $ ip link set can0 up type can bitrate 125000

and such a common interface would be netlink based as well.

> Is that something that Subhasish or someone else could to as a prerequisite
> to merging the driver?

Any ideas on how to handle hardware filtering in a generic way are
welcome. I will try to come up with a proposal sooner than later.

Wolfgang.