[PATCH 00/10] mm: Linux VM Infrastructure to support Memory Power Management
KAMEZAWA Hiroyuki
kamezawa.hiroyu at jp.fujitsu.com
Mon Jun 13 00:47:01 EDT 2011
On Fri, 27 May 2011 18:01:28 +0530
Ankita Garg <ankita at in.ibm.com> wrote:
> Hi,
>
I'm sorry if you've answered already.
Is memory hotplug is too bad and cannot be enhanced for this purpose ?
I wonder
- make section-size smaller (IIUC, IBM's system has 16MB section size)
- add per section statistics
- add a kind of balloon driver which does software memory offline
(which means making a contiguous chunk of free pages of section_size
by page migration) in background with regard to memory usage statistics.
If system says "need more memory!", balloon driver can online pages.
can work for your purpose. It can allow you page isolatation and
controls in 16MB unit. If you need whole rework of memory hotplug, I think
it's better to rewrite memory hotplug, too.
Thanks,
-Kame
> Modern systems offer higher CPU performance and large amount of memory in
> each generation in order to support application demands. Memory subsystem has
> began to offer wide range of capabilities for managing power consumption,
> which is driving the need to relook at the way memory is managed by the
> operating system. Linux VM subsystem has sophisticated algorithms to
> optimally manage the scarce resources for best overall system performance.
> Apart from the capacity and location of memory areas, the VM subsystem tracks
> special addressability restrictions in zones and relative distance from CPU as
> NUMA nodes if necessary. Power management capabilities in the memory subsystem
> and inclusion of different class of main memory like PCM, or non-volatile RAM,
> brings in new boundaries and attributes that needs to be tagged within the
> Linux VM subsystem for exploitation by the kernel and applications.
>
> This patchset proposes a generic memory regions infrastructure that can be
> used to tag boundaries of memory blocks which belongs to a specific memory
> power management domain and further enable exploitation of platform memory
> power management capabilities.
>
> How can Linux VM help memory power savings?
>
> o Consolidate memory allocations and/or references such that they are
> not spread across the entire memory address space. Basically area of memory
> that is not being referenced, can reside in low power state.
>
> o Support targeted memory reclaim, where certain areas of memory that can be
> easily freed can be offlined, allowing those areas of memory to be put into
> lower power states.
>
> What is a Memory Region ?
> -------------------------
>
> Memory regions is a generic memory management framework that enables the
> virtual memory manager to consider memory characteristics when making memory
> allocation and deallocation decisions. It is a layer of abstraction under the
> real NUMA nodes, that encapsulate knowledge of the underlying memory hardware.
> This layer is created at boot time, with information from firmware regarding
> the granularity at which memory power can be managed on the platform. For
> example, on platforms with support for Partial Array Self-Refresh (PASR) [1],
> regions could be aligned to memory unit that can be independently put into
> self-refresh or turned off (content destructive power off). On the other hand,
> platforms with support for multiple memory controllers that control the power
> states of memory, one memory region could be created for all the memory under
> a single memory controller.
>
> The aim of the alignment is to ensure that memory allocations, deallocations
> and reclaim are performed within a defined hardware boundary. By creating
> zones under regions, the buddy allocator would operate at the level of
> regions. The proposed data structure is as shown in the Figure below:
>
>
> -----------------------------
> |N0 |N1 |N2 |N3 |.. |.. |Nn |
> -----------------------------
> / \ \
> / \ \
> / \ \
> ------------ | ------------
> | Mem Rgn0 | | | Mem Rgn3 |
> ------------ | ------------
> | | |
> | ------------ | ---------
> | | Mem Rgn1 | ->| zones |
> | ------------ ---------
> | | ---------
> | ----->| zones |
> | --------- ---------
> ->| zones |
> ---------
>
> Memory regions enable the following :
>
> o Sequential allocation of memory in the order of memory regions, thus
> ensuring that greater number of memory regions are devoid of allocations to
> begin with
> o With time however, the memory allocations will tend to be spread across
> different regions. But the notion of a region boundary and region level
> memory statistics will enable specific regions to be evacuated using
> targetted allocation and reclaim.
>
> Lumpy reclaim and other memory compaction work by Mel Gorman, would further
> aid in consolidation of memory [4].
>
> Memory regions is just a base infrastructure that would enable the Linux VM to
> be aware of the physical memory hardware characterisitics, a pre-requisite to
> implementing other sophisticated algorithms and techniques to actually
> conserve power.
>
> Advantages
> -----------
>
> Memory regions framework works with existing memory management data
> structures and only adds one more layer of abstraction that is required to
> capture special boundaries and properties. Most VM code paths work similar
> to current implementation with additional traversal of zone data structures
> in pre-defined order.
>
> Alternative Approach:
>
> There are other ways in which memory belonging to the same power domain could
> be grouped together. Fake NUMA nodes under a real NUMA node could encapsulate
> information about the memory hardware units that can be independently power
> managed. With minimal code changes, the same functionality as memory regions
> can be achieved. However, the fake NUMA nodes is a non-intuitive solution,
> that breaks the NUMA semantics and is not generic in nature. It would present
> an incorrect view of the system to the administrator, by showing that it has a
> greater number of NUMA nodes than actually present.
>
> Challenges
> ----------
>
> o Memory interleaving is typically used on all platforms to increase the
> memory bandwidth and hence memory performance. However, in the presence of
> interleaving, the amount of idle memory within the hardware domain reduces,
> impacting power savings. For a given platform, it is important to select an
> interleaving scheme that gives good performance with optimum power savings.
>
> This is a RFC patchset with minimal functionality to demonstrate the
> requirement and proposed implementation options. It has been tested on TI
> OMAP4 Panda board with 1Gb RAM and the Samsung Exynos 4210 board. The patch
> applies on kernel version 2.6.39-rc5, compiled with the default config files
> for the two platforms. I have turned off cgroup, memory hotplug and kexec to
> begin. Support to these framework can be easily extended. The u-boot
> bootloader does not yet export information regarding the physical memory bank
> boundaries and hence the regions are not correctly aligned to hardware and
> hence hard coded for test/demo purposes. Also, the code assumes that atleast
> one region is present in the node. Compile time exclusion of memory regions is
> a todo.
>
> Results
> -------
> Ran pagetest, a simple C program that allocates and touches a required number
> of pages, on a Samsung Exynos 4210 board with ~2GB RAM, booted with 4 memory
> regions, each with ~512MB. The allocation size used was 512MB. Below is the
> free page statistics while running the benchmark:
>
> ---------------------------------------
> | | start | ~480MB | 512MB |
> ---------------------------------------
> | Region 0 | 124013 | 1129 | 484 |
> | Region 1 | 131072 | 131072 | 130824 |
> | Region 2 | 131072 | 131072 | 131072 |
> | Region 3 | 57332 | 57332 | 57332 |
> ---------------------------------------
>
> (The total number of pages in Region 3 is 57332, as it contains all the
> remaining pages and hence the region size is not 512MB).
>
> Column 1 indicates the number of free pages in each region at the start of the
> benchmark, column 2 at about 480MB allocation and column 3 at 512MB
> allocation. The memory in regions 1,2 & 3 is free and only region0 is
> utilized. So if the regions are aligned to the hardware memory units, free
> regions could potentially be put either into low power state or turned off. It
> may be possible to allocate from lower address without regions, but once the
> page reclaim comes into play, the page allocations will tend to get spread
> around.
>
> References
> ----------
>
> [1] Partial Array Self Refresh
> http://focus.ti.com/general/docs/wtbu/wtbudocumentcenter.tsp?templateId=6123&navigationId=12037
> [2] TI OMAP$ Panda board
> http://pandaboard.org/node/224/#manual
> [3] Memory Regions discussion at Ubuntu Development Summit, May 2011
> https://wiki.linaro.org/Specs/KernelGeneralPerformanceO?action=AttachFile&do=view&target=k81-memregions.odp
> [4] Memory compaction
> http://lwn.net/Articles/368869/
>
> Ankita Garg (10):
> mm: Introduce the memory regions data structure
> mm: Helper routines
> mm: Init zones inside memory regions
> mm: Refer to zones from memory regions
> mm: Create zonelists
> mm: Verify zonelists
> mm: Modify vmstat
> mm: Modify vmscan
> mm: Reflect memory region changes in zoneinfo
> mm: Create memory regions at boot-up
>
> include/linux/mm.h | 25 +++-
> include/linux/mmzone.h | 58 +++++++--
> include/linux/vmstat.h | 22 ++-
> mm/mm_init.c | 51 ++++---
> mm/mmzone.c | 36 ++++-
> mm/page_alloc.c | 368 +++++++++++++++++++++++++++++++-----------------
> mm/vmscan.c | 284 ++++++++++++++++++++-----------------
> mm/vmstat.c | 77 ++++++----
> 8 files changed, 581 insertions(+), 340 deletions(-)
>
> --
> 1.7.4
>
> --
> To unsubscribe, send a message with 'unsubscribe linux-mm' in
> the body to majordomo at kvack.org. For more info on Linux MM,
> see: http://www.linux-mm.org/ .
> Fight unfair telecom internet charges in Canada: sign http://stopthemeter.ca/
> Don't email: <a href=mailto:"dont at kvack.org"> email at kvack.org </a>
>
More information about the linux-arm-kernel
mailing list