[PATCH] arm: omap3: beagle: Ensure msecure is mux'd to be able to set the RTC

[Alexander Holler]

Hello,

Am 09.06.2011 09:40, schrieb Igor Grinberg:
> On 06/09/11 03:21, Alexander Holler wrote:

> I see. Is the new patch version somehow provides better functionality?
> You configure the gpio for output, this means that the pin is actually driven
> and not just relies on internal pullup (which can vary from chip to chip).
> I know nothing about that msecure stuff, but may be it is better to drive the pin,
> then just configuring the mux (enabling internal pullup)...

Just using the internal pullup was enough with my BeagleBoard C4.

>> Below is an updated version. The gpio_export() might be removed too.
>
> The original patch version is already in Linus' tree, so this one will not apply as it is.
> If you decide it is better then the original one, then it must be rebased.
> Otherwise, looks OK.

I'm fine with either version, so no new patch is necessary. ;)

Regards,

Alexander