[PATCH v2] net/smsc911x: add device tree probe support
Grant Likely
grant.likely at secretlab.ca
Fri Jul 29 11:53:54 EDT 2011
On Fri, Jul 29, 2011 at 04:43:16PM +0800, Shawn Guo wrote:
> It adds device tree probe support for smsc911x driver.
>
> Signed-off-by: Shawn Guo <shawn.guo at linaro.org>
> Cc: Grant Likely <grant.likely at secretlab.ca>
> Cc: Steve Glendinning <steve.glendinning at smsc.com>
> Cc: David S. Miller <davem at davemloft.net>
Some comments below, and I asked a question on the older version about
the actual model name vs. compatible, but otherwise it looks right and
you can add my:
Reviewed-by: Grant Likely <grant.likely at secretlab.ca>
> ---
> Changes since v1:
> * Instead of getting irq line from gpio number, it use irq domain
> to keep platform_get_resource(IORESOURCE_IRQ) works for dt too.
> * Use 'lan9115' the first model that smsc911x supports in the match
> table
> * Use reg-shift and reg-io-width which already used in of_serial for
> shift and access size binding
>
> Documentation/devicetree/bindings/net/smsc911x.txt | 38 +++++++++
> drivers/net/smsc911x.c | 85 +++++++++++++++++---
> 2 files changed, 112 insertions(+), 11 deletions(-)
> create mode 100644 Documentation/devicetree/bindings/net/smsc911x.txt
>
> diff --git a/Documentation/devicetree/bindings/net/smsc911x.txt b/Documentation/devicetree/bindings/net/smsc911x.txt
> new file mode 100644
> index 0000000..271c454
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/smsc911x.txt
> @@ -0,0 +1,38 @@
> +* Smart Mixed-Signal Connectivity (SMSC) LAN911x/912x Controller
> +
> +Required properties:
> +- compatible : Should be "smsc,lan<model>", "smsc,lan9115"
> +- reg : Address and length of the io space for SMSC LAN
> +- interrupts : Should contain SMSC LAN interrupt line
> +- interrupt-parent : Should be the phandle for the interrupt controller
> + that services interrupts for this device
> +- phy-mode : String, operation mode of the PHY interface.
> + Supported values are: "mii", "gmii", "sgmii", "tbi", "rmii",
> + "rgmii", "rgmii-id", "rgmii-rxid", "rgmii-txid", "rtbi", "smii".
> +
> +Optional properties:
> +- reg-shift : Specify the quantity to shift the register offsets by
> +- reg-io-width : Specify the size (in bytes) of the IO accesses that
> + should be performed on the device. Valid value for SMSC LAN is
> + 2 or 4. If it's omitted or invalid, the size would be 2.
> +- smsc,irq-active-high : Indicates the IRQ polarity is active-low
Which is it? Active high or active low? The property doesn't match
the description.
> +- smsc,irq-push-pull : Indicates the IRQ type is push-pull
What exactly does "push-pull" mean here?
> +- smsc,force-internal-phy : Forces SMSC LAN controller to use
> + internal PHY
> +- smsc,force-external-phy : Forces SMSC LAN controller to use
> + external PHY
> +- smsc,save-mac-address : Indicates that mac address needs to be saved
> + before resetting the controller
> +- local-mac-address : 6 bytes, mac address
> +
> +Examples:
> +
> +lan9220 at f4000000 {
> + compatible = "smsc,lan9220", "smsc,lan9115";
> + reg = <0xf4000000 0x2000000>;
> + phy-mode = "mii";
> + interrupt-parent = <&gpio1>;
> + interrupts = <31>;
> + reg-io-width = <4>;
> + smsc,irq-push-pull;
> +};
> diff --git a/drivers/net/smsc911x.c b/drivers/net/smsc911x.c
> index b9016a3..75c08a5 100644
> --- a/drivers/net/smsc911x.c
> +++ b/drivers/net/smsc911x.c
> @@ -53,6 +53,10 @@
> #include <linux/phy.h>
> #include <linux/smsc911x.h>
> #include <linux/device.h>
> +#include <linux/of.h>
> +#include <linux/of_device.h>
> +#include <linux/of_gpio.h>
> +#include <linux/of_net.h>
> #include "smsc911x.h"
>
> #define SMSC_CHIPNAME "smsc911x"
> @@ -2095,8 +2099,58 @@ static const struct smsc911x_ops shifted_smsc911x_ops = {
> .tx_writefifo = smsc911x_tx_writefifo_shift,
> };
>
> +#ifdef CONFIG_OF
> +static int __devinit smsc911x_probe_config_dt(
> + struct smsc911x_platform_config *config,
> + struct device_node *np)
> +{
> + const char *mac;
> + u32 width = 0;
> +
> + if (!np)
> + return -ENODEV;
> +
> + config->phy_interface = of_get_phy_mode(np);
> +
> + mac = of_get_mac_address(np);
> + if (mac)
> + memcpy(config->mac, mac, ETH_ALEN);
> +
> + of_property_read_u32(np, "reg-shift", &config->shift);
> +
> + of_property_read_u32(np, "reg-io-width", &width);
> + if (width == 4)
> + config->flags |= SMSC911X_USE_32BIT;
> +
> + if (of_get_property(np, "smsc,irq-active-high", NULL))
> + config->irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_HIGH;
> +
> + if (of_get_property(np, "smsc,irq-push-pull", NULL))
> + config->irq_type = SMSC911X_IRQ_TYPE_PUSH_PULL;
> +
> + if (of_get_property(np, "smsc,force-internal-phy", NULL))
> + config->flags |= SMSC911X_FORCE_INTERNAL_PHY;
> +
> + if (of_get_property(np, "smsc,force-external-phy", NULL))
> + config->flags |= SMSC911X_FORCE_EXTERNAL_PHY;
> +
> + if (of_get_property(np, "smsc,save-mac-address", NULL))
> + config->flags |= SMSC911X_SAVE_MAC_ADDRESS;
> +
> + return 0;
> +}
> +#else
> +static inline int smsc911x_probe_config_dt(
> + struct smsc911x_platform_config *config,
> + struct device_node *np)
> +{
> + return -ENODEV;
> +}
> +#endif /* CONFIG_OF */
> +
> static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
> {
> + struct device_node *np = pdev->dev.of_node;
> struct net_device *dev;
> struct smsc911x_data *pdata;
> struct smsc911x_platform_config *config = pdev->dev.platform_data;
> @@ -2107,13 +2161,6 @@ static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
>
> pr_info("Driver version %s\n", SMSC_DRV_VERSION);
>
> - /* platform data specifies irq & dynamic bus configuration */
> - if (!pdev->dev.platform_data) {
> - pr_warn("platform_data not provided\n");
> - retval = -ENODEV;
> - goto out_0;
> - }
> -
> res = platform_get_resource_byname(pdev, IORESOURCE_MEM,
> "smsc911x-memory");
> if (!res)
> @@ -2152,9 +2199,6 @@ static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
> irq_flags = irq_res->flags & IRQF_TRIGGER_MASK;
> pdata->ioaddr = ioremap_nocache(res->start, res_size);
>
> - /* copy config parameters across to pdata */
> - memcpy(&pdata->config, config, sizeof(pdata->config));
> -
> pdata->dev = dev;
> pdata->msg_enable = ((1 << debug) - 1);
>
> @@ -2164,10 +2208,22 @@ static int __devinit smsc911x_drv_probe(struct platform_device *pdev)
> goto out_free_netdev_2;
> }
>
> + retval = smsc911x_probe_config_dt(&pdata->config, np);
> + if (retval && config) {
> + /* copy config parameters across to pdata */
> + memcpy(&pdata->config, config, sizeof(pdata->config));
The following will do the same but is type-safe:
pdata->config = *config;
> + retval = 0;
> + }
> +
> + if (retval) {
> + SMSC_WARN(pdata, probe, "Error smsc911x config not found");
> + goto out_unmap_io_3;
> + }
> +
> /* assume standard, non-shifted, access to HW registers */
> pdata->ops = &standard_smsc911x_ops;
> /* apply the right access if shifting is needed */
> - if (config->shift)
> + if (pdata->config.shift)
> pdata->ops = &shifted_smsc911x_ops;
>
> retval = smsc911x_init(dev);
> @@ -2314,6 +2370,12 @@ static const struct dev_pm_ops smsc911x_pm_ops = {
> #define SMSC911X_PM_OPS NULL
> #endif
>
> +static const struct of_device_id smsc911x_dt_ids[] = {
> + { .compatible = "smsc,lan9115", },
> + { /* sentinel */ }
> +};
> +MODULE_DEVICE_TABLE(of, smsc911x_dt_ids);
> +
> static struct platform_driver smsc911x_driver = {
> .probe = smsc911x_drv_probe,
> .remove = __devexit_p(smsc911x_drv_remove),
> @@ -2321,6 +2383,7 @@ static struct platform_driver smsc911x_driver = {
> .name = SMSC_CHIPNAME,
> .owner = THIS_MODULE,
> .pm = SMSC911X_PM_OPS,
> + .of_match_table = smsc911x_dt_ids,
> },
> };
>
> --
> 1.7.4.1
>
More information about the linux-arm-kernel
mailing list