[PATCH v2 2/6] arm: davinci: Explicitly set channel controllers' default queues

[Ben Gardiner]

On Mon, Jul 25, 2011 at 12:31 PM, Nori, Sekhar <nsekhar at ti.com> wrote:
> Hi Sergei,
>
> On Mon, Jul 25, 2011 at 19:03:45, Sergei Shtylyov wrote:
>> Hello.
>>
>> Nori, Sekhar wrote:
>>
>> >> Davinci platforms may define a default queue for each channel
>> >> controller. If one is not defined, the default queue is set to EVENTQ_1.
>> >> However, there's no way to distinguish between an unset default queue to
>> >> one that is set to EVENTQ_0, as EVENTQ_0 = 0.
>>
>> >> Explicitly specify the default queue for all channel controllers on all
>> >> Davinci platforms to EVENTQ_1, and don't overwrite it in the EDMA probe
>> >> function.
>>
>> >> One exception is the DA850 board, for which EVENTQ_1 is not a valid
>> >> option for its second channel controller. Use EVENTQ_0 instead for that
>> >> channel controller.
>>
>> >> Signed-off-by: Ido Yariv <ido at wizery.com>
>>
>> > Looks good to me. Will queue for v3.2/fixes
>>
>>     Why wait for 3.2? If this is considered a fix, it should be applied to 3.1, no?
>
> 3.2/fixes just indicates it will be queued as a fix/cleanup
> for 3.2 so it will have higher priority for merge when compared
> to a new feature.
>
> This patch doesn't really fix any existing broken functionality.
> It corrects event queue configuration for EDMA CC1 on DA850 for
> which there are no current users in mainline.
>
> So, not sending for v3.1.

If it's not too late:

Tested this patch and it fixes SD/MMC1 support on da850.

Tested-by: Ben Gardiner <bengardiner at nanometrics.ca>

Thanks, Ido!

Best Regards,
Ben Gardiner

---
Nanometrics Inc.
http://www.nanometrics.ca