[PATCH 2/2] OMAP2+: PM: SR: add suspend/resume handlers

[Menon, Nishanth]

On Fri, Jul 22, 2011 at 04:13, Felipe Balbi <balbi at ti.com> wrote:
> Hi,
>
> On Fri, Jul 22, 2011 at 12:55:53AM -0500, Nishanth Menon wrote:
>> Suspend and Resume paths are safe enough to do it in
>> the standard LDM suspend/resume handlers where one can
>> sleep. Add suspend/resume handlers for SmartReflex.
>>
>> Signed-off-by: Nishanth Menon <nm at ti.com>
>> ---
>>  arch/arm/mach-omap2/smartreflex.c |   87 +++++++++++++++++++++++++++++++++++++
>>  1 files changed, 87 insertions(+), 0 deletions(-)
>>
>> diff --git a/arch/arm/mach-omap2/smartreflex.c b/arch/arm/mach-omap2/smartreflex.c
>> index 33a027f..fb90bd2 100644
>> --- a/arch/arm/mach-omap2/smartreflex.c
>> +++ b/arch/arm/mach-omap2/smartreflex.c
>> @@ -39,6 +39,7 @@ struct omap_sr {
>>       int                             ip_type;
>>       int                             nvalue_count;
>>       bool                            autocomp_active;
>> +     bool                            is_suspended;
>>       u32                             clk_length;
>>       u32                             err_weight;
>>       u32                             err_minlimit;
>> @@ -684,6 +685,12 @@ void omap_sr_enable(struct voltagedomain *voltdm)
>>       if (!sr->autocomp_active)
>>               return;
>>
>> +     if (sr->is_suspended) {
>> +             dev_dbg(&sr->pdev->dev, "%s: in suspended state\n", __func__);
>> +             return;
>> +     }
>
> I wonder why you get these called if you're in suspend state. If this is
> called by some other driver, then shouldn't you pm_runtime_get_sync();
> do_whatever_you_need_to_do(); and pm_runtime_put(); rather then just
> returning ?

because we have two state machines running in parallel - cpu idle and
dvfs(cpufreq, and other dependent domain voltage scaling) and SR
driver is just one - it does it's own get_sync and put_sync_suspend.
we cannot guarentee that the SR enable/disable calls can be properly
sequenced unless we use suspend lockouts. SmartReflex driver is an
independent entity of it's own - yeah we can do the same as we have
done historically in the omap[34]_idle paths(which is disable SR after
we have disabled interrupts), but in case of suspend(unlike in idle),
we do *know* that SR will have to be disabled - hence doing it earlier
as part of standard LDM suspend sequences is more opportunistic.

Regards,
Nishanth Menon