[PATCH 3/4] MTD: pxa3xx_nand: enable multiple chip select support

[Igor Grinberg]

On 07/07/11 09:26, Lei Wen wrote:

> Hi Igor && Daniel,
>
> On Wed, Jul 6, 2011 at 3:41 PM, Igor Grinberg <grinberg at compulab.co.il> wrote:
>> On 07/04/11 12:25, Lei Wen wrote:
>>
>>>  #ifdef CONFIG_PM
>>> @@ -1203,8 +1259,12 @@ static int pxa3xx_nand_resume(struct platform_device *pdev)
>>>  {
>>>       struct pxa3xx_nand_info *info = platform_get_drvdata(pdev);
>>>
>>> -     nand_writel(info, NDTR0CS0, info->host->ndtr0cs0);
>>> -     nand_writel(info, NDTR1CS0, info->host->ndtr1cs0);
>>> +     /*
>>> +      * Directly set the chip select to a invalid value,
>>> +      * then the driver would reset the timing according
>>> +      * to current chip select at the beginning of cmdfunc
>>> +      */
>>> +     info->cs = 0xff;
>> Thinking of this for the second (or third) time,
>> If you have keep config enabled and have only one nand chip,
>> this will brake the keep config...
>>
>> Daniel,
>>
>> have you tested the suspend/resume with this patch?
>> (and keep_config on?)
>>
> Do you still have concern with this change?
> If not, I would push the next round of patch set including merging
> patch 3 and 4.

Though I can't test it right now, but yes it looks like it breaks
the keep_config after the resume (actually it disables the keep_config silently).

I think you need here some kind of check if keep_config is enabled.
keep_config is enabled means that only one chip select is used for NAND
and you don't need to reset the timings.


-- 
Regards,
Igor.