[PATCH RESEND v2 3/3] net/fec: add device tree probe support

Shawn Guo shawn.guo at linaro.org
Wed Jul 6 12:22:33 EDT 2011


It adds device tree probe support for fec driver.

Signed-off-by: Jason Liu <jason.hui at linaro.org>
Signed-off-by: Shawn Guo <shawn.guo at linaro.org>
Cc: David S. Miller <davem at davemloft.net>
Cc: Grant Likely <grant.likely at secretlab.ca>
Acked-by: Grant Likely <grant.likely at secretlab.ca>
---
Resend with changes:
 * use of_get_named_gpio for phy-reset-gpios

 Documentation/devicetree/bindings/net/fsl-fec.txt |   24 +++++
 drivers/net/fec.c                                 |   98 +++++++++++++++++++-
 2 files changed, 117 insertions(+), 5 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/net/fsl-fec.txt

diff --git a/Documentation/devicetree/bindings/net/fsl-fec.txt b/Documentation/devicetree/bindings/net/fsl-fec.txt
new file mode 100644
index 0000000..de43951
--- /dev/null
+++ b/Documentation/devicetree/bindings/net/fsl-fec.txt
@@ -0,0 +1,24 @@
+* Freescale Fast Ethernet Controller (FEC)
+
+Required properties:
+- compatible : Should be "fsl,<soc>-fec"
+- reg : Address and length of the register set for the device
+- interrupts : Should contain fec interrupt
+- phy-mode : String, operation mode of the PHY interface.
+  Supported values are: "mii", "gmii", "sgmii", "tbi", "rmii",
+  "rgmii", "rgmii-id", "rgmii-rxid", "rgmii-txid", "rtbi", "smii".
+- phy-reset-gpios : Should specify the gpio for phy reset
+
+Optional properties:
+- local-mac-address : 6 bytes, mac address
+
+Example:
+
+fec at 83fec000 {
+	compatible = "fsl,imx51-fec", "fsl,imx27-fec";
+	reg = <0x83fec000 0x4000>;
+	interrupts = <87>;
+	phy-mode = "mii";
+	phy-reset-gpios = <&gpio1 14 0>; /* GPIO2_14 */
+	local-mac-address = [00 04 9F 01 1B B9];
+};
diff --git a/drivers/net/fec.c b/drivers/net/fec.c
index 7ae3f28..720aa63 100644
--- a/drivers/net/fec.c
+++ b/drivers/net/fec.c
@@ -44,6 +44,10 @@
 #include <linux/platform_device.h>
 #include <linux/phy.h>
 #include <linux/fec.h>
+#include <linux/of.h>
+#include <linux/of_device.h>
+#include <linux/of_gpio.h>
+#include <linux/of_net.h>
 
 #include <asm/cacheflush.h>
 
@@ -78,6 +82,17 @@ static struct platform_device_id fec_devtype[] = {
 	{ }
 };
 
+enum fec_type {
+	IMX27_FEC,
+	IMX28_FEC,
+};
+
+static const struct of_device_id fec_dt_ids[] = {
+	{ .compatible = "fsl,imx27-fec", .data = &fec_devtype[IMX27_FEC], },
+	{ .compatible = "fsl,imx28-fec", .data = &fec_devtype[IMX28_FEC], },
+	{ /* sentinel */ }
+};
+
 static unsigned char macaddr[ETH_ALEN];
 module_param_array(macaddr, byte, NULL, 0);
 MODULE_PARM_DESC(macaddr, "FEC Ethernet MAC address");
@@ -734,8 +749,22 @@ static void __inline__ fec_get_mac(struct net_device *ndev)
 	 */
 	iap = macaddr;
 
+#ifdef CONFIG_OF
+	/*
+	 * 2) from device tree data
+	 */
+	if (!is_valid_ether_addr(iap)) {
+		struct device_node *np = fep->pdev->dev.of_node;
+		if (np) {
+			const char *mac = of_get_mac_address(np);
+			if (mac)
+				iap = (unsigned char *) mac;
+		}
+	}
+#endif
+
 	/*
-	 * 2) from flash or fuse (via platform data)
+	 * 3) from flash or fuse (via platform data)
 	 */
 	if (!is_valid_ether_addr(iap)) {
 #ifdef CONFIG_M5272
@@ -748,7 +777,7 @@ static void __inline__ fec_get_mac(struct net_device *ndev)
 	}
 
 	/*
-	 * 3) FEC mac registers set by bootloader
+	 * 4) FEC mac registers set by bootloader
 	 */
 	if (!is_valid_ether_addr(iap)) {
 		*((unsigned long *) &tmpaddr[0]) =
@@ -1358,6 +1387,52 @@ static int fec_enet_init(struct net_device *ndev)
 	return 0;
 }
 
+#ifdef CONFIG_OF
+static int __devinit fec_get_phy_mode_dt(struct platform_device *pdev)
+{
+	struct device_node *np = pdev->dev.of_node;
+
+	if (np)
+		return of_get_phy_mode(np);
+
+	return -ENODEV;
+}
+
+static int __devinit fec_reset_phy(struct platform_device *pdev)
+{
+	int err, phy_reset;
+	struct device_node *np = pdev->dev.of_node;
+
+	if (!np)
+		return -ENODEV;
+
+	phy_reset = of_get_named_gpio(np, "phy-reset-gpios", 0);
+	err = gpio_request_one(phy_reset, GPIOF_OUT_INIT_LOW, "phy-reset");
+	if (err) {
+		pr_warn("FEC: failed to get gpio phy-reset: %d\n", err);
+		return err;
+	}
+
+	gpio_set_value(phy_reset, 1);
+
+	return 0;
+}
+#else /* CONFIG_OF */
+static inline int fec_get_phy_mode_dt(struct platform_device *pdev)
+{
+	return -ENODEV;
+}
+
+static inline int fec_reset_phy(struct platform_device *pdev)
+{
+	/*
+	 * In case of platform probe, the reset has been done
+	 * by machine code.
+	 */
+	return 0;
+}
+#endif /* CONFIG_OF */
+
 static int __devinit
 fec_probe(struct platform_device *pdev)
 {
@@ -1366,6 +1441,11 @@ fec_probe(struct platform_device *pdev)
 	struct net_device *ndev;
 	int i, irq, ret = 0;
 	struct resource *r;
+	const struct of_device_id *of_id;
+
+	of_id = of_match_device(fec_dt_ids, &pdev->dev);
+	if (of_id)
+		pdev->id_entry = of_id->data;
 
 	r = platform_get_resource(pdev, IORESOURCE_MEM, 0);
 	if (!r)
@@ -1397,9 +1477,16 @@ fec_probe(struct platform_device *pdev)
 
 	platform_set_drvdata(pdev, ndev);
 
-	pdata = pdev->dev.platform_data;
-	if (pdata)
-		fep->phy_interface = pdata->phy;
+	fep->phy_interface = fec_get_phy_mode_dt(pdev);
+	if (fep->phy_interface < 0) {
+		pdata = pdev->dev.platform_data;
+		if (pdata)
+			fep->phy_interface = pdata->phy;
+		else
+			fep->phy_interface = PHY_INTERFACE_MODE_MII;
+	}
+
+	fec_reset_phy(pdev);
 
 	/* This device has up to three irqs on some platforms */
 	for (i = 0; i < 3; i++) {
@@ -1534,6 +1621,7 @@ static struct platform_driver fec_driver = {
 #ifdef CONFIG_PM
 		.pm	= &fec_pm_ops,
 #endif
+		.of_match_table = fec_dt_ids,
 	},
 	.id_table = fec_devtype,
 	.probe	= fec_probe,
-- 
1.7.4.1





More information about the linux-arm-kernel mailing list