[PATCH-V2] OMAP3EVM:FIX: Reset the smsc911x ethernet controller in board_init

[Kevin Hilman]

"Hiremath, Vaibhav" <hvaibhav at ti.com> writes:

>> -----Original Message-----
>> From: Hiremath, Vaibhav
>> Sent: Tuesday, January 25, 2011 8:53 PM
>> To: linux-omap at vger.kernel.org
>> Cc: Hiremath, Vaibhav; Varadarajan, Charulatha
>> Subject: [PATCH-V2] OMAP3EVM:FIX: Reset the smsc911x ethernet controller
>> in board_init
>> 
>> With addition of hwmod support to gpio, the ethernet controller
>> goes undetected for OMAP35xEVM. So explicitly assert the reset signal to
>> ethernet controller smsc911x -
>> 
>> 	- GPIO7 (>=RevG version of EVM's)
>> 	- GPIO64 (<=RevD version of EVM's)
>> 
>> This patch is based on intial version from Charulatha V, reference
>> to original discussion -
>> http://www.mail-archive.com/linux-omap@vger.kernel.org/msg35784.html
>> Signed-off-by: Vaibhav Hiremath <hvaibhav at ti.com>
>> Signed-off-by: Charulatha V <charu at ti.com>
>> Tested-by: Kevin Hilman <khilman at ti.com>
>> ---
>> Since Kevin reported that this patch doesn't get applied cleanly,
>> so I am reposting it again after making sure that it gets applied cleanly.
>> 
> [Hiremath, Vaibhav] Oops, missed linux-arm-kernel list, adding here.
>
> Not sure whether I need to repost keeping linux-arm-kernel?
>

Also, did you post the smc911x driver fix yet that is needed for testing
with newer kernels?

Kevin