[PATCH-V2] OMAP3EVM:FIX: Reset the smsc911x ethernet controller in board_init
Kevin Hilman
khilman at ti.com
Thu Jan 27 14:58:33 EST 2011
"Hiremath, Vaibhav" <hvaibhav at ti.com> writes:
>> -----Original Message-----
>> From: Hiremath, Vaibhav
>> Sent: Tuesday, January 25, 2011 8:53 PM
>> To: linux-omap at vger.kernel.org
>> Cc: Hiremath, Vaibhav; Varadarajan, Charulatha
>> Subject: [PATCH-V2] OMAP3EVM:FIX: Reset the smsc911x ethernet controller
>> in board_init
>>
>> With addition of hwmod support to gpio, the ethernet controller
>> goes undetected for OMAP35xEVM. So explicitly assert the reset signal to
>> ethernet controller smsc911x -
>>
>> - GPIO7 (>=RevG version of EVM's)
>> - GPIO64 (<=RevD version of EVM's)
>>
>> This patch is based on intial version from Charulatha V, reference
>> to original discussion -
>> http://www.mail-archive.com/linux-omap@vger.kernel.org/msg35784.html
>> Signed-off-by: Vaibhav Hiremath <hvaibhav at ti.com>
>> Signed-off-by: Charulatha V <charu at ti.com>
>> Tested-by: Kevin Hilman <khilman at ti.com>
>> ---
>> Since Kevin reported that this patch doesn't get applied cleanly,
>> so I am reposting it again after making sure that it gets applied cleanly.
>>
> [Hiremath, Vaibhav] Oops, missed linux-arm-kernel list, adding here.
>
> Not sure whether I need to repost keeping linux-arm-kernel?
Yes, please repost.
Kevin
>
>> arch/arm/mach-omap2/board-omap3evm.c | 39
>> +++++++++++++++++++++++++++++++++-
>> 1 files changed, 38 insertions(+), 1 deletions(-)
>>
>> diff --git a/arch/arm/mach-omap2/board-omap3evm.c b/arch/arm/mach-
>> omap2/board-omap3evm.c
>> index 323c380..97e0f65 100644
>> --- a/arch/arm/mach-omap2/board-omap3evm.c
>> +++ b/arch/arm/mach-omap2/board-omap3evm.c
>> @@ -58,6 +58,13 @@
>> #define OMAP3EVM_ETHR_ID_REV 0x50
>> #define OMAP3EVM_ETHR_GPIO_IRQ 176
>> #define OMAP3EVM_SMSC911X_CS 5
>> +/*
>> + * Eth Reset signal
>> + * 64 = Generation 1 (<=RevD)
>> + * 7 = Generation 2 (>=RevE)
>> + */
>> +#define OMAP3EVM_GEN1_ETHR_GPIO_RST 64
>> +#define OMAP3EVM_GEN2_ETHR_GPIO_RST 7
>>
>> static u8 omap3_evm_version;
>>
>> @@ -124,10 +131,15 @@ static struct platform_device
>> omap3evm_smsc911x_device = {
>>
>> static inline void __init omap3evm_init_smsc911x(void)
>> {
>> - int eth_cs;
>> + int eth_cs, eth_rst;
>> struct clk *l3ck;
>> unsigned int rate;
>>
>> + if (get_omap3_evm_rev() == OMAP3EVM_BOARD_GEN_1)
>> + eth_rst = OMAP3EVM_GEN1_ETHR_GPIO_RST;
>> + else
>> + eth_rst = OMAP3EVM_GEN2_ETHR_GPIO_RST;
>> +
>> eth_cs = OMAP3EVM_SMSC911X_CS;
>>
>> l3ck = clk_get(NULL, "l3_ck");
>> @@ -136,6 +148,27 @@ static inline void __init
>> omap3evm_init_smsc911x(void)
>> else
>> rate = clk_get_rate(l3ck);
>>
>> + /* Configure ethernet controller reset gpio */
>> + if (cpu_is_omap3430()) {
>> + if (gpio_request(eth_rst, "SMSC911x gpio") < 0) {
>> + pr_err(KERN_ERR "Failed to request %d for smsc911x\n",
>> + eth_rst);
>> + return;
>> + }
>> +
>> + if (gpio_direction_output(eth_rst, 1) < 0) {
>> + pr_err(KERN_ERR "Failed to set direction of %d for" \
>> + " smsc911x\n", eth_rst);
>> + return;
>> + }
>> + /* reset pulse to ethernet controller*/
>> + usleep_range(150, 220);
>> + gpio_set_value(eth_rst, 0);
>> + usleep_range(150, 220);
>> + gpio_set_value(eth_rst, 1);
>> + usleep_range(1, 2);
>> + }
>> +
>> if (gpio_request(OMAP3EVM_ETHR_GPIO_IRQ, "SMSC911x irq") < 0) {
>> printk(KERN_ERR "Failed to request GPIO%d for smsc911x IRQ\n",
>> OMAP3EVM_ETHR_GPIO_IRQ);
>> @@ -658,6 +691,10 @@ static struct omap_board_mux board_mux[] __initdata =
>> {
>> OMAP_PIN_OFF_WAKEUPENABLE),
>> OMAP3_MUX(MCSPI1_CS1, OMAP_MUX_MODE4 | OMAP_PIN_INPUT_PULLUP |
>> OMAP_PIN_OFF_INPUT_PULLUP |
>> OMAP_PIN_OFF_OUTPUT_LOW),
>> + OMAP3_MUX(SYS_BOOT5, OMAP_MUX_MODE4 | OMAP_PIN_INPUT_PULLUP |
>> + OMAP_PIN_OFF_NONE),
>> + OMAP3_MUX(GPMC_WAIT2, OMAP_MUX_MODE4 | OMAP_PIN_INPUT_PULLUP |
>> + OMAP_PIN_OFF_NONE),
>> { .reg_offset = OMAP_MUX_TERMINATOR },
>> };
>> #endif
>> --
>> 1.6.2.4
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majordomo at vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
More information about the linux-arm-kernel
mailing list