[PATCH 2/2] DM9000B: Fix PHY power for network down/up

[Henry Nestler]

On 21.02.2011 12:14, Sergei Shtylyov wrote:
> On 21-02-2011 0:45, Henry Nestler wrote:
> 
>> DM9000 revision B needs 1 ms delay after PHY power on (see spec), and PHY
>> power must on in register
> 
>     Couldn't parse that.

This can read in manual DM900B-12-DS-F02 from September 2 2010, Page 14:
"If this Register 1FH bit 0 is updated from '1' to '0', the all
Registers can not be accessed within 1ms."

The example driver code waits 2 ms.

>> diff --git a/drivers/net/dm9000.c b/drivers/net/dm9000.c
>> index 2d4c4fc..5925569 100644
>> --- a/drivers/net/dm9000.c
>> +++ b/drivers/net/dm9000.c
> [...]
>> @@ -1194,6 +1191,10 @@ dm9000_open(struct net_device *dev)
>>   	if (request_irq(dev->irq, dm9000_interrupt, irqflags, dev->name, dev))
>>   		return -EAGAIN;
>>
>> +	/* GPIO0 on pre-activate PHY, Reg 1F is not set by reset */
>> +	iow(db, DM9000_GPR, 0);	/* REG_1F bit0 activate phyxcer */
>> +	udelay(1000); /* delay needs by DM9000B */
> 
>     Why not mdelay(1)?

Because udelay is the base of mdelay.
See include/linux/delay.h:31

#define mdelay(n) ... udelay((n)*1000)

-- 
Henry N.