[PATCH 1/7] Add a mfd IPUv3 driver

[Jason Chen]

hi, Sascha,

I have few comments for this patch.

> +#define MX51_IPU_CHANNEL_CSI0                   0
> +#define MX51_IPU_CHANNEL_CSI1                   1
> +#define MX51_IPU_CHANNEL_CSI2                   2
> +#define MX51_IPU_CHANNEL_CSI3                   3
> +#define MX51_IPU_CHANNEL_MEM_BG_SYNC           23
> +#define MX51_IPU_CHANNEL_MEM_FG_SYNC           27
> +#define MX51_IPU_CHANNEL_MEM_DC_SYNC           28
> +#define MX51_IPU_CHANNEL_MEM_FG_SYNC_ALPHA     31
> +#define MX51_IPU_CHANNEL_MEM_DC_ASYNC          41
> +#define MX51_IPU_CHANNEL_ROT_ENC_MEM           45
> +#define MX51_IPU_CHANNEL_ROT_VF_MEM            46
> +#define MX51_IPU_CHANNEL_ROT_PP_MEM            47
> +#define MX51_IPU_CHANNEL_ROT_ENC_MEM_OUT       48
> +#define MX51_IPU_CHANNEL_ROT_VF_MEM_OUT                49
> +#define MX51_IPU_CHANNEL_ROT_PP_MEM_OUT                50
> +#define MX51_IPU_CHANNEL_MEM_BG_SYNC_ALPHA     51
Had better use MX5_IPU as prefix because it's same value in MX5X.

> +
> +       ipu_idmac_reg = ioremap(ipu_base + IPU_IDMAC_REG_BASE, PAGE_SIZE);
> +       if (!ipu_idmac_reg) {
> +               ret = -ENOMEM;
> +               goto failed_ioremap2;
> +       }
> +
> +       ret = ipu_mipi_setup();
> +       if (ret)
> +               goto failed_mipi_setup;
I dont know what's the best way to do it, but I think you had better
consider mx53 platform, so maybe this mipi_setup function and also
below ipu hw reset could be set in platform data.
> +
> +       ipu_clk = clk_get(&pdev->dev, "ipu");
> +       if (IS_ERR(ipu_clk)) {
> +               ret = PTR_ERR(ipu_clk);
> +               dev_err(&pdev->dev, "clk_get failed with %d", ret);
> +               goto failed_clk_get;
> +       }
> +
> +       ipu_get();
> +
> +       ret = request_irq(irq1, ipu_irq_handler, IRQF_DISABLED, pdev->name,
> +                       &pdev->dev);
> +       if (ret) {
> +               dev_err(&pdev->dev, "request irq %d failed with: %d\n", irq1, ret);
> +               goto failed_request_irq1;
> +       }
> +
> +       ret = request_irq(irq2, ipu_irq_handler, IRQF_DISABLED, pdev->name,
> +                       &pdev->dev);
> +       if (ret) {
> +               dev_err(&pdev->dev, "request irq %d failed with: %d\n", irq2, ret);
> +               goto failed_request_irq2;
> +       }
> +
> +       ipu_reset();