[PATCH 2/4] spi/pl022: disable core voltage when idle
Grant Likely
grant.likely at secretlab.ca
Tue Feb 15 17:09:25 EST 2011
On Tue, Feb 08, 2011 at 01:03:32PM +0100, Linus Walleij wrote:
> This utilizes the new core voltage switch to power off the PL022
> core voltage when it's not in use transmitting packets, if and
> only if a core voltage switch is available.
>
> Cc: Russell King <rmk+kernel at arm.linux.org.uk>
> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
Applied, thanks.
g.
> ---
> drivers/spi/amba-pl022.c | 17 +++++++++++++----
> 1 files changed, 13 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/spi/amba-pl022.c b/drivers/spi/amba-pl022.c
> index 4220aad..8fdf530 100644
> --- a/drivers/spi/amba-pl022.c
> +++ b/drivers/spi/amba-pl022.c
> @@ -508,9 +508,10 @@ static void giveback(struct pl022 *pl022)
> msg->state = NULL;
> if (msg->complete)
> msg->complete(msg->context);
> - /* This message is completed, so let's turn off the clocks! */
> + /* This message is completed, so let's turn off the clocks & power */
> clk_disable(pl022->clk);
> amba_pclk_disable(pl022->adev);
> + amba_vcore_disable(pl022->adev);
> }
>
> /**
> @@ -1475,9 +1476,11 @@ static void pump_messages(struct work_struct *work)
> /* Setup the SPI using the per chip configuration */
> pl022->cur_chip = spi_get_ctldata(pl022->cur_msg->spi);
> /*
> - * We enable the clocks here, then the clocks will be disabled when
> - * giveback() is called in each method (poll/interrupt/DMA)
> + * We enable the core voltage and clocks here, then the clocks
> + * and core will be disabled when giveback() is called in each method
> + * (poll/interrupt/DMA)
> */
> + amba_vcore_enable(pl022->adev);
> amba_pclk_enable(pl022->adev);
> clk_enable(pl022->clk);
> restore_state(pl022);
> @@ -2123,8 +2126,12 @@ pl022_probe(struct amba_device *adev, struct amba_id *id)
> goto err_spi_register;
> }
> dev_dbg(dev, "probe succeded\n");
> - /* Disable the silicon block pclk and clock it when needed */
> + /*
> + * Disable the silicon block pclk and any voltage domain and just
> + * power it up and clock it when it's needed
> + */
> amba_pclk_disable(adev);
> + amba_vcore_disable(adev);
> return 0;
>
> err_spi_register:
> @@ -2189,9 +2196,11 @@ static int pl022_suspend(struct amba_device *adev, pm_message_t state)
> return status;
> }
>
> + amba_vcore_enable(adev);
> amba_pclk_enable(adev);
> load_ssp_default_config(pl022);
> amba_pclk_disable(adev);
> + amba_vcore_disable(adev);
> dev_dbg(&adev->dev, "suspended\n");
> return 0;
> }
> --
> 1.7.3.2
>
More information about the linux-arm-kernel
mailing list