[PATCH 0/5] Change omap DEBUG_LL code to use inituart for AUTO_ZRELADDR and ARM_PATCH_PHYS_VIRT

[Poddar, Sourav]

On Fri, Feb 4, 2011 at 6:56 AM, Tony Lindgren <tony at atomide.com> wrote:
> Here are the changes to make omap DEBUG_LL code generic using
> the new inituart macro posted in a separate series. This allows
> leaving out the dependency to the uncompress code and allows
> error messages when trying to boot a wrong zImage.
>
> Adding support for new machines should be only additional two
> lines of assembly per machine after these patches.
>
> Regards,
>
> Tony
>
> ---
>
> Tony Lindgren (5):
>      omap: Remove code configuring the DEBUG_LL serial port using uncompress code
>      omap: Use inituart to configure the debug serial port based on machine ID
>      omap: Add support for CONFIG_AUTO_ZRELADDR for DEBUG_LL
>      omap: Combine debug-macro.S for omap1 and omap2+
>      omap: Add CONFIG_AUTO_ZRELADDR and CONFIG_ARM_PATCH_PHYS_VIRT to defconfigs
>
>
>  arch/arm/configs/omap1_defconfig               |    2
>  arch/arm/configs/omap2plus_defconfig           |    2
>  arch/arm/mach-omap1/include/mach/debug-macro.S |   98 ---------
>  arch/arm/mach-omap1/serial.c                   |    7 +
>  arch/arm/mach-omap2/include/mach/debug-macro.S |  138 -------------
>  arch/arm/mach-omap2/serial.c                   |    7 +
>  arch/arm/plat-omap/include/plat/debug-macro.S  |  257 ++++++++++++++++++++++++
>  arch/arm/plat-omap/include/plat/serial.h       |   34 ---
>  arch/arm/plat-omap/include/plat/uncompress.h   |   32 +--
>  9 files changed, 284 insertions(+), 293 deletions(-)
>  create mode 100644 arch/arm/plat-omap/include/plat/debug-macro.

Boot tested linux-next branch with omap2plus_defconfig using NFS filesystem
along with the above 5 patch series and
2 patch series (Allow using machine ID for DEBUG_LL macros)
on Omap 2420,2430,3430 SDPs and Omap4 blaze.

Tested-by: Sourav Poddar<sourav.poddar at ti.com>