[PATCHv4 00/13] ARM: add initial support for Picochip picoXcell SoC
jamie at jamieiles.com
Tue Feb 8 09:52:15 EST 2011
On Wed, Feb 02, 2011 at 12:03:19PM +0000, Jamie Iles wrote:
> This patch series adds support for the Picochip picoXcell series of
> femtocell SoC's. There are currently two device families - PC3X2 and
> PC3X3. Both include an ARM1176JZ-S, 100Mb Ethernet controller, 2xDMA
> controllers, eFuses, crypto offload engines and Picochip's array
> processor the picoArray. This patch series adds support for the base
> chip support including timers, gpio, pin muxing, clocks and pm and also
> the PC7302 development board that can take either PC3X2 or PC3X3 devices.
> - debug-8250: add a 32 bit mode:
> Changes since v3 include:
> - Move to fixed sched_clock() implementation.
> - Remove excessive use of __init directives.
> - Simplify pm to allow drivers to manage all clks.
> This also picks up on the CPU_V6K and PLAT_PHYS_OFFSET changes. I've
> also removed the SRAM patch to try and just get the core support in and
> make it simpler for review.
ping. Anyone have any feedback on these patches or anything to make
them easier to review?
More information about the linux-arm-kernel