[PATCH 3/4] spi/pl022: remove dangling status check

[Linus Walleij]

From: Virupax Sadashivpetimath <virupax.sadashivpetimath at stericsson.com>

Signed-off-by: Virupax Sadashivpetimath <virupax.sadashivpetimath at stericsson.com>
Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
---
 drivers/spi/amba-pl022.c |    2 --
 1 files changed, 0 insertions(+), 2 deletions(-)

diff --git a/drivers/spi/amba-pl022.c b/drivers/spi/amba-pl022.c
index 8fdf530..2b591f0 100644
--- a/drivers/spi/amba-pl022.c
+++ b/drivers/spi/amba-pl022.c
@@ -1906,8 +1906,6 @@ static int pl022_setup(struct spi_device *spi)
 	    && ((pl022->master_info)->enable_dma)) {
 		chip->enable_dma = true;
 		dev_dbg(&spi->dev, "DMA mode set in controller state\n");
-		if (status < 0)
-			goto err_config_params;
 		SSP_WRITE_BITS(chip->dmacr, SSP_DMA_ENABLED,
 			       SSP_DMACR_MASK_RXDMAE, 0);
 		SSP_WRITE_BITS(chip->dmacr, SSP_DMA_ENABLED,
-- 
1.7.3.2