[PATCH 2/4] OMAP: OneNAND: determine frequency in one place
Adrian Hunter
adrian.hunter at nokia.com
Mon Feb 7 03:46:59 EST 2011
OneNAND frequency is determined when calculating
GPMC timings. Return that value instead of determining it
again in the OMAP OneNAND driver.
Signed-off-by: Adrian Hunter <adrian.hunter at nokia.com>
---
arch/arm/mach-omap2/gpmc-onenand.c | 10 ++++++----
arch/arm/plat-omap/include/plat/onenand.h | 2 +-
drivers/mtd/onenand/omap2.c | 28 +++++-----------------------
3 files changed, 12 insertions(+), 28 deletions(-)
diff --git a/arch/arm/mach-omap2/gpmc-onenand.c b/arch/arm/mach-omap2/gpmc-onenand.c
index 3a4307b..46786a6 100644
--- a/arch/arm/mach-omap2/gpmc-onenand.c
+++ b/arch/arm/mach-omap2/gpmc-onenand.c
@@ -123,7 +123,7 @@ static void set_onenand_cfg(void __iomem *onenand_base, int latency,
static int omap2_onenand_set_sync_mode(struct omap_onenand_platform_data *cfg,
void __iomem *onenand_base,
- int freq)
+ int *freq_ptr)
{
struct gpmc_timings t;
const int t_cer = 15;
@@ -136,7 +136,7 @@ static int omap2_onenand_set_sync_mode(struct omap_onenand_platform_data *cfg,
int tick_ns, div, fclk_offset_ns, fclk_offset, gpmc_clk_ns, latency;
int first_time = 0, hf = 0, vhf = 0, sync_read = 0, sync_write = 0;
int err, ticks_cez;
- int cs = cfg->cs;
+ int cs = cfg->cs, freq = *freq_ptr;
u32 reg;
if (cfg->flags & ONENAND_SYNC_READ) {
@@ -330,16 +330,18 @@ static int omap2_onenand_set_sync_mode(struct omap_onenand_platform_data *cfg,
set_onenand_cfg(onenand_base, latency, sync_read, sync_write, hf, vhf);
+ *freq_ptr = freq;
+
return 0;
}
-static int gpmc_onenand_setup(void __iomem *onenand_base, int freq)
+static int gpmc_onenand_setup(void __iomem *onenand_base, int *freq_ptr)
{
struct device *dev = &gpmc_onenand_device.dev;
/* Set sync timings in GPMC */
if (omap2_onenand_set_sync_mode(gpmc_onenand_data, onenand_base,
- freq) < 0) {
+ freq_ptr) < 0) {
dev_err(dev, "Unable to set synchronous mode\n");
return -EINVAL;
}
diff --git a/arch/arm/plat-omap/include/plat/onenand.h b/arch/arm/plat-omap/include/plat/onenand.h
index affe87e..86118dc 100644
--- a/arch/arm/plat-omap/include/plat/onenand.h
+++ b/arch/arm/plat-omap/include/plat/onenand.h
@@ -20,7 +20,7 @@ struct omap_onenand_platform_data {
int gpio_irq;
struct mtd_partition *parts;
int nr_parts;
- int (*onenand_setup)(void __iomem *, int freq);
+ int (*onenand_setup)(void __iomem *, int *freq_ptr);
int dma_channel;
u8 flags;
u8 regulator_can_sleep;
diff --git a/drivers/mtd/onenand/omap2.c b/drivers/mtd/onenand/omap2.c
index ac31f46..3e1bb95 100644
--- a/drivers/mtd/onenand/omap2.c
+++ b/drivers/mtd/onenand/omap2.c
@@ -63,7 +63,7 @@ struct omap2_onenand {
struct completion dma_done;
int dma_channel;
int freq;
- int (*setup)(void __iomem *base, int freq);
+ int (*setup)(void __iomem *base, int *freq_ptr);
struct regulator *regulator;
};
@@ -581,7 +581,7 @@ static int __adjust_timing(struct device *dev, void *data)
/* DMA is not in use so this is all that is needed */
/* Revisit for OMAP3! */
- ret = c->setup(c->onenand.base, c->freq);
+ ret = c->setup(c->onenand.base, &c->freq);
return ret;
}
@@ -673,7 +673,7 @@ static int __devinit omap2_onenand_probe(struct platform_device *pdev)
}
if (pdata->onenand_setup != NULL) {
- r = pdata->onenand_setup(c->onenand.base, c->freq);
+ r = pdata->onenand_setup(c->onenand.base, &c->freq);
if (r < 0) {
dev_err(&pdev->dev, "Onenand platform setup failed: "
"%d\n", r);
@@ -718,8 +718,8 @@ static int __devinit omap2_onenand_probe(struct platform_device *pdev)
}
dev_info(&pdev->dev, "initializing on CS%d, phys base 0x%08lx, virtual "
- "base %p\n", c->gpmc_cs, c->phys_base,
- c->onenand.base);
+ "base %p, freq %d MHz\n", c->gpmc_cs, c->phys_base,
+ c->onenand.base, c->freq);
c->pdev = pdev;
c->mtd.name = dev_name(&pdev->dev);
@@ -754,24 +754,6 @@ static int __devinit omap2_onenand_probe(struct platform_device *pdev)
if ((r = onenand_scan(&c->mtd, 1)) < 0)
goto err_release_regulator;
- switch ((c->onenand.version_id >> 4) & 0xf) {
- case 0:
- c->freq = 40;
- break;
- case 1:
- c->freq = 54;
- break;
- case 2:
- c->freq = 66;
- break;
- case 3:
- c->freq = 83;
- break;
- case 4:
- c->freq = 104;
- break;
- }
-
#ifdef CONFIG_MTD_PARTITIONS
r = parse_mtd_partitions(&c->mtd, part_probes, &c->parts, 0);
if (r > 0)
--
1.7.0.4
More information about the linux-arm-kernel
mailing list